0
Mercury villager 95 van changed battery car won't start lights come on etc?
Wiki User
∙ 14y ago
if the lights inside your van dont turn on as well that means your alternator fuse is blown, headlights and taillights will work but the car wont start until you replace the fuse. fuse is located in the engine bay at the front area by the radiator.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Is there a fuse for the license plate lights on a 1996 Mercury villager?
Should be the same circuit for parking/tail/dash lights
The lights and radio come on but the car won't start. What's wrong?
-- battery -- battery cable -- connection between battery cable and battery A fault in any of these would still supply the small current used by the lights and radio, but not the huge battery current required for starting.
If my car won't start and the lights are not coming on but it can be jumped off what may be my problem?
The battery is dieing down and you should go and get a new battery or get your battery charged
Your brake blinker and hazard lights dont work you changed the fuse in the fuse box you changed the brake light bulbs and you changed the the oob switch on the brake pedal what could it be?
Have an electrician check the wiring that goes to the brake lights in the trunk of the car.
Car will not start but all your gauge lights are flickering?
Could be a battery problem, discharged, dead or dirty/loose battery connections.
What if your brake lights are stuck on can you unplug 1 side of your battery on a 94 mercury villager?
"Stuck" brake lights indicate that the brake light switch on the brake pedal is broken. It should be replaced.
Changed battery in 1997 mercury villager now wont start lights come on and starter is good What is wrong?
You probably need the original key fob for the car. This is regardless if you have an alarm for the car. I've changed the battery twice in the last five years for my 97 Villager and each time I've had to "reset" the "alarm" via the key fob. The last time, I had to uncable the battery twice because it would not "reset" using the key fob before finally accepting the "unlock/disarm" from the key fob.
Is there a fuse for the license plate lights on a 1996 Mercury villager?
Should be the same circuit for parking/tail/dash lights
Wiring diagram for 1994 mercury villager?
dash lights don't work, but the fues is good.
How do you replace the dash lights in a 1997 mercury villager?
The instrument cluster needs to be removed to get at the bulbs.
Why are the brake lights on your 2001 mercury villager stuck on?
If the brake lights stay on that probably means the switch on the brake pedal that activates them is defective.
How do you replace dash lights 1994 mercury villager van?
To replace lamps the cluster must be removed.
Why don't my 1994 mercury villager brake lights shut off with out disconnecting the battery?
Two plastic pads on the brake pedal which press on two switches on a bracket are missing. Meaning the switches never get pressed and the brake lights stay on and run down the battery. See a dealer to put new plastic "buttons" in the pedal.
Why do the brake lights stay on 2001 mercury villager?
This is usually cause by a stuck brake light switch on the brake pedal. Replace it.
Why does my 1996 mercury villager warning lights all blink and pulse even with the key out?
I figured it out myself...it was the inhibitor relay got wet.
2002 Mercury Villager brake light lights up on rough roads.?
Brake light switch needs adjusting or replacing. It is too sensitive.
Where is located the fuse for the dashboard lights in the 1994 Mercury Villager?
That is in the fuse panel inside the car. Marked I/P illum (instrument panel illumination)
