http://www.engineeringtoolbox.com/ansi-steel-pipes-d_305.html
3/4 inch steel pipe if making a strong double layer frame.
It can be colored, polish, etc...The most beautiful are polished.
Yep, you can weld steel to stainless and you can weld stainless to steel. You can use steel or stainless welding rod in either case but the steel or steel welding rod will of course rust.
A Corncob pipe.
It depends on the type of system you have. 1 pipe in, or 1 pipe in and 1 pipe out. Single pipe in/out, try replacing the relief valve or simply shimming the end of the radiator opposite where the pipe comes in. This lets water bleed out of the radiator and stops the klanging.
21`foot
The answer depends on the thickess of the pipe. The universal formula for carbon steel pipe weight is 10.6802 x T x (OD-T) T=Thickness of pipe OD=Outside Diameter If your pipe was carbon steel with a thickness of .375" it would be 238.8 lbs/ft
Schedule 40 PVC is the type and thickness of water pipe.
assuming it's hollow. 10.68*ID*(OD-ID)
7.227
The outside diameter (OD) of a 40-inch nominal bore black steel pipe is typically 40 inches, as the nominal size refers to the approximate internal diameter of the pipe. However, the actual OD for standard pipe sizes can vary; for a 40-inch nominal bore, the standard OD is approximately 42.16 inches according to the American National Standards Institute (ANSI) specifications. This discrepancy is due to the wall thickness of the pipe, which is accounted for in the nominal size.
Not sure what you mean by pressure fittings. Threaded fittings for steel pipe are pressure fittings. Steel pipe with a 3/4" O.D. is known as 1/2" I.P.S. (Iron Pipe Size) pipe.
Kindly adviseSCH20 are suitable for 18" exhaust pipe urgently and are there any spec to justify if suitable on SCH20 instead of SCH40 pipe?
=3.14 * (Diameter of pipe in Mtr. - wall thickness in Mtr. ) * Wall Thickness in Mtr. * 7850
Max USD 100 Million Mohsin Safdar
1/8 pipe schedule
OD is Outside Diameter - at least when you are talking about pipe...