Oil paint ? are you refering to an "oil-based" paint or artist's oil's? you can add "Japan drier" to both, and it only takes a little bit .usally "unfininished plywood would "suck up" paint,as quick as you applied it.Remember you have to stir it up real good.
Ensure that it is clean and oil-free; remove any mold or mildew using a bleach solution; allow the surface to dry completely prior to applying your acrylic deck paint.
no
When you've been using latex paint. Then clean them only in water.
If the plywood is for an indoor craft project: Water base enamel. For outdoors: Oil base with UV inhibitors Key is using the proper base or primer or undercoating. Follow paint manufacturer's recommendation.
Probably the primer surface was contaminated before the topcoat was put on. Another option is that the paint was applied in hot weather, over a surface that was not cool enough to paint over. Still another option is that it was applied with a foam roller using too much pressure. That could have introduced air into the surface. The fix is to sand the surface smooth, clean, then reapply the paint according to the manufacturer's instructions.
Clean via power spray, scrape and sand, prime and paint.
yes it is because if it can be used for floorings then shorly it can resist a bit of water
Yep.
Marine grade plywood and treated plywood aren't the same thing. Marine grade plywood has special glues and woods that will withstand constant immersion in water. Treated plywood is regular plywood that has been run through a pressure treating cycle. Paint will stick to treated plywood if you make sure to let it dry for a few months before you paint.
plywood
i HAVE USED PAINT THINNER TO CLEAN ACNE OFF MY FACE WHICH WAS DEEPLY ROOTED.. SO YES IT CAN CLEAN JUST ABOUT ANYTHING THAT MAKES THINGS NASTY AND UGLY
Water based paint does very well on plywood. The finish depends on the type of paint.
Ensure that it is clean and oil-free; remove any mold or mildew using a bleach solution; allow the surface to dry completely prior to applying your acrylic deck paint.
Anything epoxy based, but be aware you will need epoxy thinner for clean up.
Yes. Simply spackle the plywood or roll on plaster with a paint roller. Let it dry, sand if you like, and then paint.
In pointillism, the paint it applied as small dots of colour to form an image.
You don't prime the paint, you prime what the paint is applied to.