0
What else can I help you with?
Where is the intake plenum?
The intake plenum on most cars is bolted directly atop the intake manifold. This is where the air goes after passing through the throttle body.
Where is the Egr valve on trans am?
on the 305 EFI its located direct center underneath the intake plenum. have fun. its a nightmare.
Where are the vacuum lines located on a 1999 Dodge Grand Caravan?
Under the hood, they are plugged into the Intake plenum by the MAF.
What could be the cause No engine light but car idles high?
First check your throttle body sensor and then your (iac) motor. Last but not least it could be your plenum gasket or a leak in your vacuum system
Your 1991 4 runner will not stay crank and it loses power Also you have to start it with starter fluid what is wrong?
if you mean it doesnt crank long enough to start you probably need a battery. i suspect that the battery is dead because it takes so long to start. long crank times on these engines is usually caused by a bad cold start injector (found in the intake plenum on the passenger side, it has a small diameter steel fuel line and a 2 wire plug connected to it. held in place by 2 10mm screws) or the cold start injector time switch (found in the back of the engine behind the intake plenum, it sits in an aluminum casting that holds other water temp sensors and has a blue plug with 2 wires on it). replace these 2 items and you should be fine as far as hard starting goes.
How do you replace the intake plenum gasket on a 1999 Ford Contour?
very carefully
Where is the plenum gasket found on dodge 2500 5.9?
It is on the underside of the intake manifold
Is a upper intake gasket and plenum gasket the same thing on a 2002 F150 V6 4.2L engine?
yes it is
How much does it cost to replace plentum gasket on ford windstar 2002?
Which plenum-intake or. . . .
Where is the starter on my 1995 Cadillac Seville?
starter is located under intake plenum on 4.6 cadillac motor .which is the engine valley between cylinder heads.Can be replaced without changing intake gaskets if careful about lifting intake plenum/gaskets are silicone rubber and can be reused if not damaged
Manifold gasket same as plenum gasket?
The manifold gasket is the same as the plenum gasket. The manifold gasket is a barrier between the manifold and the engine block.
What is the plenum gasket?
The plenum gasket is a sealing component located between the intake manifold (or plenum) and the engine's cylinder head. Its primary function is to prevent air and fluid leaks, ensuring that the engine receives the correct air-fuel mixture for optimal performance. A faulty plenum gasket can lead to vacuum leaks, poor engine performance, and increased emissions. Regular inspection and replacement are important for maintaining engine efficiency.
Is plenum gasket the same as head gasket?
No.
After beginning to produce white smoke from the exhaust a 98 Bonneville dies and would not start again what could be causing this?
White smoke is coolant in the cylinders. Died and won't restart cause the spark plugs are shorted with coolant. If you keep trying to start it without fixing it you could bend a rod! Most likely it is a failed intake manifold gasket or intake plenum gasket or the intake plenum itself. Don't drive the car cause if it is the plenum leaking coolant into the engine it can fill a cylinder with coolant and do major damage when you try to start it. No way to know for sure which of the three it is without pulling the plenum. If you're pulling that you might as well change the intake manifold gasket too. Could be a bad head gasket
What gaskets will you need to repair a coolant leak coming from the intake manifold on a 1996 Camaro 3800 V6?
You will need a intake manifold set and possibly a plenum gasket set.
How to change the rear spark plugs on Camry 2002 V6?
You have to remove the throttle body/air intake plenum to get to the rear plugs. I believe the plenum is supported with two or three stays which are hard to see. You will need a new gasket for the plenum/intake manifold interface.One post on Toyota Nation Forum says that it can be done without removing the plenum. I think he is skilled at beating the clock at a repair shop.
What is the plenum on a 2002 Kia Sedona?
The plenum is the intake manifold.
