All of the torque specifications for vehicles can be found in Haynes Repair Manuals available at most auto parts stores.
Torque head to 50-55 ft/lbs
The torque is 65-70 ft lbs. Looking at the head with the valve cover area away from you the bolts are numbered top row 7, 5, 1, 3, 10 and the bottom row 11, 9, 4, 2, 6, 8, 12. Tighten them in in order from 1 to 12. The rocker arm bolts are torqued to 45- 50 ft lbs.
The torque sequence is 25 ft lbs, 50 ft lbs, 50 ft lbs, and a 90 degree turn.
The Lexus cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
I believe the Kodiak muzzleloaders were made by Connecticut Valley Arms. You might try the customer service at CVA's website.
50 lb/ft lubricated with oil. Check out the link I posted.
Rocker studs lubricated with oil, 50 ft/lbs. Valve covers 3 lb/ft.
With the valve fully closed and the lifter fully at the down position, tighten the adjusting nut until there is no up and down travel in the push rod. Then tighten the adjusting nut 1/4 turn. This is only if you have hydraulic lifters. Tighten the rocker studs to 50 ft/lb of torque. These are the bolts holding the rocker assembly in place.
i need a Cylinder Head Torque Specs for a 1999 dodge caravan 4 cyl 25 ft lbs, 50 ft lbs, 50 ft lbs, quarter turn.
The head bolt torque specs of a 1985 3.8 Ford Ltd. is 50 to 55 ft lbs. This 65 to 71 Nm belongs to a 6-cylinder torque sequence engine.
50 ft lbs, then 150 ft lbs.
A complete list of Ford E3 50 torque specifications can be obtained from most Ford dealerships. The torque specifications can be found at many auto-parts stores.
Torque the inner nut to 350 lbs/ft., back it off, re-torque it to 50 lbs/ft. Torque the outer nut to 250 lbs/ft.
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
Tighten to 50 ft/lb,then back off all rocker shafts,then 22ft/lb plus 60 degrees which is one flat of a bolt "hexagon"
The torque specs and pattern on the head bolts for a 1991 Toyota pickup with a 3.0 EFI is 50 foot pounds per bolt. The pattern is 4,5,6,3,7,2,8,1 with 1 being at the front of the engine.
step 1 25 step 2 50 step 3 50 step 4 90 degrees