answersLogoWhite

0

you would probably want to call your local machine shop or part store.....but ,the valve lash adjustment for a Chevy 350 with hydrolic lifters,I believe, starts with the #1 piston at top dead center...tighten the intake valve rocker arm just enough so that the plunger inside the lifter is just below the snap ring...then go to the next piston in the firing order for the intake valves...when all the intakes are done you should be at #6 piston tdc...then go through the same steps with the exhaust valves...again I would double check, it's been a while. good luck

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you ajust the valves on a 1991 Chevy 350 small block?

take off the valve covers, and the rocker arms will have adjusting nuts on them, tighten them to zero lash and the back off 1/4 turn.


Where would you add oil to a 350 Chevy small block engine?

One of the valve covers.


How do you put oil in a Chevy small block 350?

The front of the valve cover, on the drivers side will have a cap.


Where can you find valve covers for 1955 Chevy 350 heads?

The 350 engine was introduced in 1968. A 1955 small block would be a 265 or 283.


Difference from a big block 350 to a small block 350?

There is no such thing as a big block 350.


What better big block 350 or small block 350?

there is no such thing as a big block 350


Setting valves on 350 with hydralic lifters and roller rockers?

Chevy 350 small block engines with hydralic lifters set at 0 lash. That means start the engine and adjust the valve until it just quits clicking. Then tighten the nut approx 3/4-1 turn then set the next one.


Where can you find the transmission stick on Chevy 350 small block?

Pass side between the valve cover, and firewall.


Does a 350 long block have more power than a 350 small block?

They are both the same engines. You refer to a long block as being a compleat engine assy. 350 small block is what it means. It's a 350 and that is called a small block.


Small Block Chevy 350 timing?

how do i set the timing for a chevy 350 small block?


How does a big block 350 work?

The 350 engine is a small block, not a big block.


Why is a ford 350 block called a 427. i was watching a show where they were building a 427 but the gut said it was a 350 block... plus the valve covers said 427 Cobra.?

A 350 cid is a small block Chevy engine. A Ford F350 is a one ton truck not an engine.