It looks like a cheap, tubular socket made out of stamped steel, often with a thick wire handle
looks like a spark plug with a wire
you take the spark plug wire off and get you a 13/16 wrench and the plug will be right underneath the gas tank,you can get to it better on the left side of the bike.The side were the clutch lever is.Just unscrew and put the new one in.
The spark plug gap is 09.96 The spark plug gap is 09.96
The rubber end on the spark plug wire.
To produce a spark.
use the spark plug wrench and use used mirror to find the rear spark plug, you need to two person to do this, then fell the spark plug rear with your hands then apply the spark wrench to remove the old spark plug.
Most snow blowers have the spark plug on top of the motor :to change a spark plug you get a spark plug wrench (take wire cap off the plug) put wrench on spark plug then turn counter clock wise to take it out. To put a new one back in reverse the proses
Take off the gas cap. Take off the big plastic cover with a socket and wrench.Then put the gas cap back on. Then pull of the spark plug boot. Then take off the spark plug with a spark plug socket and wrench. It should be 13/16" socket with 3/8" drive wrench. I Think the spark plug gap is 0.025 but you would have to look at a manual.
A special 18 mm spark plug wrench. Use the Honda spark plug Wrench which comes with the standard tool kit below the seat. Use this and you will get all the plugs out easily.This 18 mm wrench is thinner and longer than a regular spark plug wrench. If the original wrench is no longer in your bike, you have to buy a new one.
Remove the spark plug wires from the spark plugs, use an extension for your Allen wrench, and use a spark plug socket to remove the spark plug.
To perform a weed eater spark plug replacement, first ensure the engine is cool. Locate the spark plug on the engine and use a spark plug wrench to remove it. Check the gap on the new spark plug and adjust if necessary. Install the new spark plug by hand, then tighten it with the wrench. Finally, reconnect the spark plug wire and test the weed eater to ensure it is running smoothly.
With a Spark plug Wrench
Buy a plug wrench.
Get a spark plug socket and wrench that fits the plug body and remove it by turning counter-clockwise.
They don't have spark plugs, therefore, no need for a wrench
most likely it will be a 5/8" spark plug socket.
3/4