You have a problem with the EGR system, the pintle positon circuit.
No, there are sever variations of the 4L60E, you have to get the right one. Check with a tranny shop to make sure you've got the right one.
You need to have a diagnostic meter to read the codes, then book to tell you what they mean.
Turn on that fast blinking signal light and check to see if the front and rear signal lights are both working, chances are you have a burned out bulb. If both front and rear bulbs are flashing fast, replace the flasher relay.
James Earl Carter Jr. (39th US President) is 93 years old (birthdate: October 1, 1924).
A flashing transmission warning light can indicate a number of transmission problems. The most common problem is low transmission fluid.
A '96 jimmy does not have a body control module (bcm), it does, however, have an engine control module (ecm) located ontop of the coolant reservoir.
i think 35mm
Hand brake? I thought the last GMC with a hand brake was in 68, but I could be wrong.
When owning a car, it is important to know and remember the gas tank size. The 1996 GMC Jimmy has a gas tank that holds up to 19 gallons of gas.
The fuel pressure regulator in that 96 GMC 4.3 TBI is located in the throttle body.
it is located on the lower left side of the timing cover
It is on the left side of the dashboard,you can only see it when the door is open
Probably a crossed wire or electrical short.
a defective starter switch
The brake lights on a 96 Jimmy are operated by the brake light switch, mounted on the brake pedal assembly. If the switch is bad the lights could stay on or off, or be sporadic.
If it is the original drain plug it should take a 15mm.
When my 4-wheel drive stopped working on my 96 GMC Jimmy it turned out to be the air hose that goes into the actuator was cracked. It was an easy fix. the actuator is under the battery pan, I would start following those hoses and see if any are disconnected or broken.