the two white wires. one is for lambda heater.along with the grey wire.the other white wire is lambda itself it gets its earth from the exhaust. and the black wire is the signal wire
Lambda is o2 sensor in exhaust pipe.
The lambda sensor reads the oxygen in the exhaust stream.
All Down stream Lambda sensors are located(screwed into) the exhaust pipe, after the catalytic converter( usually with in a footafter the cat.).
Trouble code P1320 means: Distributor Signal Interrupt
The P1135 is set when the Engine Control Module detects a heated oxygen sensor heater circuit malfunction. This could be caused by a faulty air-fuel ratio sensor or a faulty engine control module.
you plug them into the sensors on the exhaust downpipe!
Lambda is o2 sensor in exhaust pipe.
The lambda sensor reads the oxygen in the exhaust stream.
Year, engine?? Normaly lambda sensor is below exhaust collector
where is the right hand bank lambda sensor on a V12 1992 XJS
The Lambda Sensor is situated in exhaust downpipe with connector rear of engine N/S.
oxygen sensor
P0161 is a Lambda heater sensor malfunction (oxygen sensor) located in the front section of the exhaust system.
Lambda Sond is an Oxygen sensor which is very important to the fuel system.
A Nox sensor is very similar to a lambda probe, but its dedicated to measuring oxides of nitrogen in the exhaust gas. It looks pretty much the same and goes into the exhaust just like a lambda probe.
Lambda Sensor.
down pipe