A valve job for your 1999 GMC Suburban will cost approximately $800. The parts will cost around $200 and require 10 hours of labor.
If the 1999 Suburban noise is a sort of loud banging noise, the problem could be that the engine have jumped time. Jumping time would cause the noise and jerking in the engine.
NO You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Your GMC Suburban emergency brake release cable is held in place with a swivel nut on each end of the cable. Loosen the swivel nut to remove the cable. Reverse the process to install the new emergency brake release cable.
try replacing the actuator valve on the front axle
the proper gap size for all vin. #'s of 2003 Chevy and gmc suburbans is 0.060 as per the Chevy owners manual. I have a 2003 Chevy suburban and I am replacing my plugs tomorrow, good day kind friend. Danny Romero Louisiana
Under the pan on the valve body!
Depends on the year. Here is a site that has pictures of an EGR valve for a 1997 - 1999 Suburban: http://www.racepages.com/products/?D=gmc+suburban+egr+valve&Nty=1&Ntx=mode+matchallpartial&Ntk=Main&N=4294950670+4294963366+9926&Dx=mode+matchallpartial&Ntt=gmc+suburban+egr+valve Go to www.racepages.com and search for an EGR valve for your year rig.
on a 1999 gmc 1500 suburban 5.7 l where is the ac condensor
In the rear of the vehicle attached to the rear evaporator, you will need to remove the complete assembly to replace the expansion valve......
looking for help on the brake light ground wire location for 1999 gmc suburban 4x4
An ECU is essentially the brain for a 1999 GMC Suburban. Without an ECU the truck will not be able to operate at all.
My 99 gmc suburban is stuck in 4 wheel drice low
The starter relay on a 1999 GMC Suburban with the bib block engine is located on the solenoid for the starter. The solenoid for the starter is on top of the starter.
The PCV valve on a 1999 GMC Jimmy is located on top of the engine, on the left side. It connects the valve cover to the intake manifold.
In the fuel tank.
Yes it will bolt right up.
Answernot hard