The best answer I can think of is:
Walk away and do something else for a few minutes. When you come back, it's dry.
Watching it dry is like watching a pot waiting for it to boil.
If you are desperate, use a hair dryer, but don't get too close. It will blister.
Freezer works like magic just let it warm up a little n the minor moisture evaporate
If you have a good spray gun and a small compressor,that's a better way.
The most efficient way to paint latticework - if you can do it - is spray painting, but don't try that if it's already installed in place.
The best way to paint metal is a rather simple process: 1) sand or grind any imperfections or rust as best as possible 2) patch holes or use bondo filler if needed and smooth again 3) Apply a coat of primer (best results from an air powered spray gun; gravity fed is the best imo). let dry 4) apply desired paint colour with the spray gun (after its been cleaned with thinner). let dry 5) seal the paint colour with a clear coat finish. this is also applied with the spray gun after cleaning out the paint. clear coat comes in a variety of finishes from high gloss to flat matte.
Hi there, The best way to clean fiberglass is to use dry ice blasting.. This is often compared to sandblasting, but it's very different. Dry ice blasting (or cryogenic cleaning) is a revolutionary cleaning method in which dry ice pellets replace traditional cleaning materials. Dry ice blasting is quick & clean & generates no secondary waste material. The only waste to be disposed of is the material that is removed. The process is dry & non-conductive therefore is suitable for electronics and electric motors. Also in the case of fibreglass it is perfect as it will not affect the underlying surface as it is a non abrasive technology. Hope this helps?
Latex paint is rubberized....and it wants to stick to everything it comes in contact with, which is one of the beauties of paint. However, if you want to be able to peel paint off of something you have applied it to, just about the only way to achieve that would be to rub some Vaseline onto the surface in question. Baby powder will also work if you use enough of it.
If you have a good spray gun and a small compressor,that's a better way.
you take the paint and put it on the end of the bike first and work your way up !
You can scratch it off but that's not the best way.
Most people choose to paint fiberglass with a sprayer. The paint is sprayed in much the same way that spray paint is.
The same way all liquids dry, evaporation.
Machine or hair dryer.
You could try Qwik Dry... and yes it is spelled that way.
The most efficient way to paint latticework - if you can do it - is spray painting, but don't try that if it's already installed in place.
Spray drying
What is the best way to paint a football helmet?Just to collect not for use.
Buy a 5 gallon paint bucket from your local hardware store, spray paint it your desired color and let it dry. You may have to use a primer, depending on the spray paint that you use. You can use stencils or paint pens to put your mascot, team name or your girls name on the sides of the bucket. If you want you can also hot glue decorative ribbon around the rim of the bucket and/or lid. Once you have got the bucket decorated the way you want it you can tie ribbon around the handle. Enjoy!
the best way to get your hair straight faster is to use a straight iron and then use hair spray and gel