answersLogoWhite

0

What else can I help you with?

Continue Learning about Art & Architecture

How do you remove a starter from a 1993 Mitsubishi diamante 30l v6 sohc?

Just came in the house from doing just that. First remove the heat shield from the exhaust pipes. Next I found it's best to remove the upper radiator hose. ( Gives you room to work). This now gives you some room to get at the 2 starter hold down bolts and the nut that holds the main electrical wire to the starter. Also you can now take off the little plug that goes on top of the starter.Once you take off these bolts, the starter can be removed via the exhaust pipes. The new starter will go on alot faster you'll find. Mine did. Good luck! ***************** I just replaced the starter on a 1999 Galant 3.0 V6 (1999-2003): The starter motor is located on the front of the engine behind the exhaust pipe and next to the oil filter. First disconnect the battery. Next remove the flat, angular heat shield from the starter itself (1x 8mm nut and 2x 8mm bolts). Do NOT try to remove the heat shield from the Exhaust pipe - it can't be removed with the starter in place and it's not necessary anyway. Next remove the oil filter. You'll loose a few ounces of oil so be prepared for that with a drain pan and either cover the removed filter to keep debris out or replace it and remember to check the oil level later. Remove the small signal wire from the solenoid (released by pushing in a tiny lever with a finger tip) and also remove the 12mm nut attaching the positive battery cable to the starter. The starter is held in place by two 14mm bolts. On the engine (passenger) side, there is a 14x30mm bolt threading into the transaxle from the bottom of the starter. On the transaxle (driver) side, there is a longer 14x50mm bolt threading into the top of the starter. Funnily enough, I just replaced the battery two weeks ago. I suspect now that the power of a new battery burned up the worn brushes in the original starter.


Related Questions

What is the firing order for 1995 Ford Aerostar 30L and direction of rotation on distributor?

What is the firing order for 1995 Ford Aerostar 30L and direction of rotation on distributor?"


Cylinder Firing sequence '93 Ford Taurus GL 30L?

1-4-2-5-3-6 Distributor rotates clockwise.


What is five sixths of 30litres?

5/6 of 30L is 25L


How many moles of oxygen in 30L of oxygen gas?

At standard temperature and pressure (STP), one mole of a gas is 22.4L. So, in order to determine how many moles of O2 are in 30L, you do the following: multiply 30L O2 x 1mol O2/22.4L O2, which equals 1.34mol O2.


Can you bring a Military Tactical 30L Backpack to school?

If you can bring a military tactical 30L backpack to school will depend upon the school you are going to. Many schools are now requiring students to wear only clear backpacks, so this backpack would not be allowed.


What size engine was used in 1996 Honda Passport?

it's a 30l, with a dual over head cam...


Can you keep a yabbie in a 30L tank?

Yes you can but it would be adviseable to have a filter, deep substrate and cover glass too.


If your a size 29w 30l should you wear skinny jeans?

i would say no and that's my opinion but if you want to then yes, it's up to you


Do all 1994 Ford Ranger 40 have an EGR Valve?

yes 2002 and later 30L are the only ones not equipped with an egr valve


Name of the biggest champagne bottle is?

Largest champagne bottle size is a Melchizedek (30L) although Armand de Brignac Champagne have claimed they have the largest Champagne bottle size which is also 30L but instead they have named it the 'Midas'


How to set timing on 93 Ford Ranger 30L - can't find bolt to loosen distributor?

there should be a clamp right behind the distributor. it will be hard to get to because it is in a hole


How to set ignition timing on 30L motor?

The ignition timing is probably controlled by the computer, and cannot be manually set. Check to see if it has a distributor, if it does it may be adjustable, if not, it is not adjustable.