0
What else can I help you with?
What is the actual smoker surcharge for obamacare in ga?
it varies from carrier to carrier and it's different for each person
How do you get the C Clip off the rear Axle to remove the carrier bearing on a 1998 C1500 Chevy 4x4?
If you look at the carrier you will see a big pin that goe's through the spider gears and carrier. Turn the carrier around until you see a small bolt on the right side of it. Remove the bolt that is what holds the pin in the carrier. Then pull the pin out towards you. Then push the axel's in and the c-clips will fall out. Then put pin back in so the spider gears don't fall out.
Why you use microwaves in satellite communication?
Microwaves are used in communications because of their shorter wavelength and smaller antennae. This allows them to be more directional than lower frequency radio waves. The Microwave spectrum also has more bandwidth than the radio spectrum. They also waste less energy than Radio Waves
What is the electron carrier molecule when carrying excited electrons it becomes NADPH?
NADP
Is Coenzyme Q10 an electron carrier?
yes, a very good one actually
Comparison of amplitude modulation and frequency modulation?
Amplitude of the (high frequency) Carrier signal is varied with respect to low frequency of message signal is called amplitude modulation. Frequency of the carrier signal is varied with respect to low frequency of message signal is called frequency modulation.
What is Modulation index in Frequency modulation?
Modulation Index is the ratio of the maximum deviation frequency to the frequency of modulation. In other words it is the ratio of the spread in frequency spectrum to the frequency that was used to modulate the carrier. For FM, modulation index is given by the formula mf= df/f where, mf=modulation index for FM df=difference in carrier frequency f=frequency of the signal
Is it true that information can be carried on a carrier wave by changing or modulating either the amplitude or frequency?
in frequency modulation, frequency of carrier signal changes. so frequency variations of carrier convey all the information in frequency modulation.
List two differences between information signal and carrier signal.?
A: A carrier carry information by modulation either Amplitude or Frequency modulation. Therefore AM and FM RADIO M stand for modulation
What is FM?
FM stands for frequency modulation. The definition is: when the frequency of the carrier wave is changed in accordance with the intensity of the signal, it is called frequency modulation. In frequency modulation, only the frequency of the carrier wave is changed in accordance with the signal. However, the amplitude of the carrier wave remains unchanged.
What is the technical difference when it comes to the implementation of AM and FM?
In a analog transmitter the RF carrier have to be modulated with the analog signal either by AM or FM where in digital transmitter the carrier is simply switched on and off a off = a zero and on = a one
What is modulated frequency?
frequency modulation stands for FM (on your radio).Better Answer"frequency modulation stands for FM"No it doesn't. On the contrary, f.m. stands for frequency modulation.Frequency modulation is the method of impressing information on an r.f. carrier by changing its frequency back and forth in sympathy with the informatiion signal.
What is the deviation ratio for frequency modulation?
Deviation ratio: In a frequency modulation system, the ratio of the maximum frequency deviation of the carrier to the maximum modulating frequency of the system under specified conditions
What is the bandwidth of pulse position modulation?
probably (the carrier frequency +- the maximum frequency of the pulse train)/(the carrier frequency) but pulses have a lot of harmonics
In which analog-to-analog modulation methods does the peak amplitude of the carrier signal remain unchanged?
Frequency modulation and Phase modulation
What is the frequency deviation for frequency modulation?
Deviation ratio: In a frequency modulation system, the ratio of the maximum frequency deviation of the carrier to the maximum modulating frequency of the system under specified conditions
When does maximum frequency deviation occur?
Maximum frequency deviation occurs in frequency modulation (FM) when the modulating signal reaches its peak amplitude. This deviation represents the greatest difference between the carrier frequency and the modulated frequency. In practice, it corresponds to the point where the instantaneous frequency of the carrier signal varies the most due to the modulation, often occurring at the maximum input signal level.
