if it is a gm with the little resistor chip in it you could try to cleand the chip with alcohol to remove oils from skin and such
No, a 1991 Chrysler New Yorker does not have chip key.
The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.
GM have the codes. these keys and codes are very very expensive to replace GM seems to think if you can afford a key with a chip, u have lots of money
The thing that causes the PASSLOCK to activate is the chip, if you will. If the chip is bad, ar is unrecognizable to the system, the PASSLOCK will activate. Take it to a dealer asap. You can bypass the passlock by accessing the ignition, and cutting the yellow wire of a small 3 piece wire set that's on top of the ignition. cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire.
Hi! #85 is an 'immobilizer' code. Most likely triggered by a missing/wrong chip in a car key (spare key - with no chip?). The code reader in the steering column is anable to recognize the key.
== ==
No
yes
take the key to orchard supply.They have a free scanner for this if there is no chip they will make duplicates.
It could be as simple as replacing the ignition key. Each key has a chip that comunicates directly with the car. If the chip goes bad, the car's starter will turn over, but the engine will not start. There is no after market key that will work. You must purchase them from a dealer. Costly little buggers, roughly around $150....... what kind of vehicle is this?
You can bypass chip to set it always on and replace ignition w/o chip. This will save you a lot of headaches.
No there is no chip in the key however the ignition lock cylinder does enable and disable the theft system.
The cost of doing this would be more time consuming and more expensive than going to a locksmith or a dealer and getting a key with a chip.
No, a 1991 Chrysler New Yorker does not have chip key.
No. Blue chip stamps are no longer redeemable.
On a Chrysler vehicle with sentry key (chip key), you just have to put the key in the ignition and turn it on.On a Chrysler vehicle with sentry key (chip key), you just have to put the key in the ignition and turn it on.
The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.