0
What else can I help you with?
How do you write a performance appraisal review response?
What you need to do is to look at it objectively. If you feel that you have been sold short in any aspect, you should mention that, but in an objective and cool-headed manner.
Can you can damage your vehicle's electronic system by welding on the frame and what procedures should you follow to weld on your truck frame?
As long as you disconnect the battery (or batteries) first, you should be fine. Basically, disconnecting at least the negative cable breaks the circuit thus protecting the electronics.
What art materials should you use for sketching?
The materials used for sketching can vary depending upon the paper which is used and also the objective for the sketching. Many times, when doing simple sketching of figures, people use charcoal to help get the movement of the body. For just sketching in a sketchbook [a normal sketchbook you could find], many people use soft lead pencils.
Is a GU6 rear end differential a posi?
GU6 is just in indicator of the differential ratio a gu6 is a 3.42:1 ratio. it could be single track, limited slip or gov lock. if it is gov lock you should also have a g80 code in your glove box. if so and you tow or have tall tires be ready to replace when master pin breaks
What credentials should I ask for when hiring an event photographer?
When hiring a event photographer ask for samples of their previous work, ask about back up equipment if anything breaks or back up photographer if that one you hire comes down with an illness, Membership in a professional association, certification or a photography degree shows a level of commitment to the profession and their photographic art.
What should you do if the high power objectives lens touches or breaks the coverslip?
Take the camera to be repaired. - - - - - A high-power objective lens is part of a microscope. If it touches or breaks the coverslip, immediately notify your teacher who will inspect the instrument.
Can a specimen be viewed under a microscope using the 100x objective without a coverslip?
No, a specimen should not be viewed under a microscope using the 100x objective without a coverslip. The 100x objective requires a thin layer of immersion oil to properly focus light and achieve the necessary resolution. Without a coverslip, the specimen may be too far from the lens, resulting in poor image quality and potential damage to both the specimen and the objective lens.
Should A coverslip should always be used with wet mounts and the high-power and oil lenses?
true
You should lower a coverslip using a mounted?
To lower a coverslip onto a mounted slide, hold the coverslip at a slight angle above the specimen then gently lower it to let the mounting medium spread evenly and minimize air bubbles. Avoid pressing down too hard to prevent squashing the specimen or damaging the slide.
Why should a microscope slide and coverslips be held their edges?
A microscope slide and coverslip should be held by their edges due to leaving fingerprints and/or debris and how easily breakable they are. Leaving fingerprints or debris on either a slide of coverslip will alter the view under the microscope.
When preparing a wet mount specimen for viewing it should be covered with?
When preparing a wet mount specimen for viewing, it should be covered with a coverslip. This thin piece of glass or plastic helps to flatten the specimen, prevent contamination, and protect the microscope's lenses. Care should be taken to lower the coverslip at an angle to avoid trapping air bubbles.
Why should a glass slide and coverslip be held by its edges?
Holding a glass slide and coverslip by its edges prevents fingerprint smudges or other contaminants from interfering with the specimen being viewed under a microscope. It also helps maintain a clean surface for a clear observation.
Why should you never use the coarse adjustment on higher power?
Using the coarse adjustment on higher power can risk damaging the lens or the slide because the distance between the lens and the slide is very small. It can also cause the objective lens to hit and break the coverslip or slide. Finer adjustments should be made with the fine adjustment knob when using higher magnifications to prevent this.
How long should my resume objective be?
How long should my resume objective be? Read more topresumetemplate .com
What should be my Objectives in a college?
If this is for acceptance, then your objective should be to get your degree. Be honest about it. If this is AFTER acceptance, find your career, then GRADUATE. That should be your main objective.
Which objective should be in place both when beginning to use the microscope?
Scanning objective
What fastens two people but touches no one?
The question should be 'what fastens two people but touches only one' The answer is a 'wedding ring'
