The bad news is you will have to remove the old wallpaper. Adding another coat of primer and topcoat will most likely result in the same problem.
Unfortunately, in the attempt to save time, money, and effort by doing the least amount possible, many people end up having to take additional time, do much more work and at greater cost than doing it all the first time.
Start by scoring the paper with a tool commonly called a "paper tiger". Use medium pressure and a circular stroke. Make sure to get all of the surface.
Next use a good quality commercial wallpaper remover, mixed with warm (not hot) water. Apply the mixture to the wall with a sponge (wear gloves and protective eye gear). Allow the mixture to saturate the paper and reactivate the glue. Using a wide scraper (plastic is better than metal) peel the wallpaper from the wall.
Once the entire wall is free of the paper and the "fuzzy" backing that some papers have. Wash the wall down with a good cleaner, rinse it well and allow to dry completely.
Do any and all repairs needed to the wall surface, and prime it with a good quality primer.
Finish up with a good quality top coat and you are good to go.
I would sand it down with sand paper then paint with primer. After that apply a outdoor paint. Prep work should be smooth If you really want it to be nice hit the primer with a light sandpaper after the primer coat.
Try a heavy coat of primer/sealer. The primer should condition and adhere to your plaster walls. Once the primer sets up (dries) you can then apply anything you want to those walls.
You can paint the exterior of your above ground pool. You will first have to clean it and use sand paper to lightly scruff the surface. You should use an exterior primer to prime the surface, and then an exterior paint designed for the type of surface your are painting to paint it.
No they will not show up when dry. Sorry, I don't agree. I have been able to successfully paint watercolours on black paper.
First of all to avoid this from happening you must use a paint remover jasco paint epoxy remover works for me then apply, scrape off with plastic puttyknife take a small brush and work the corners good, use a clean rag to remove any residue wipe clean.Then sand with 150you grit sand paper,dust off surface clean of dust.I use aqua laq for my primer it dries fast and can be sanded quick two coats of this primer two coats of your top coat and i promise you the stain will not bleed through!
I would sand it down with sand paper then paint with primer. After that apply a outdoor paint. Prep work should be smooth If you really want it to be nice hit the primer with a light sandpaper after the primer coat.
it bleeds because it has to to be permanent.
Try a heavy coat of primer/sealer. The primer should condition and adhere to your plaster walls. Once the primer sets up (dries) you can then apply anything you want to those walls.
You should carefully inspect the wall board for any damage. If the paper "skin" of the wall board has peeled off with the wall paper, you will have to patch that before you can paint. Otherwise, I would recommend a good quality latex primer.
It would be better to apply a true primer, but short of that, if you sand the surface with a fine grit paper, it should have no problem accepting the paint.
You can paint the exterior of your above ground pool. You will first have to clean it and use sand paper to lightly scruff the surface. You should use an exterior primer to prime the surface, and then an exterior paint designed for the type of surface your are painting to paint it.
Scuff them up with steel wool or sand paper first. Oil paint can be put on directly. Enamel latex should adhere alright. For regular latex I would use an oil based primer first.
No they will not show up when dry. Sorry, I don't agree. I have been able to successfully paint watercolours on black paper.
First of all to avoid this from happening you must use a paint remover jasco paint epoxy remover works for me then apply, scrape off with plastic puttyknife take a small brush and work the corners good, use a clean rag to remove any residue wipe clean.Then sand with 150you grit sand paper,dust off surface clean of dust.I use aqua laq for my primer it dries fast and can be sanded quick two coats of this primer two coats of your top coat and i promise you the stain will not bleed through!
The whole idea of melamine is that not much will stick to it, not even paint. The paint might go on initially, but it won't stick. You could try roughing the surface with sandpaper and coating the roughened surface with a good automotive primer. Use a 300 grit wet/dry paper, and keep it wet while you're sanding, then after you've knocked the shine off, wipe it all down to remove the dust, let it dry thoroughly then put the primer over the surface. After the primer has dried thoroughly you can put whatever paint on it that you want. A better solution would be the cultured marble tub surrounds. They hold up much better in a damp location and they are really good looking.
Well the best ways are to have great instillation plastic cover over that high quality paper board "the wall it's self". High quality primer, High quality paint.
Yes. It's possible to use fabric paint on paper but that will take a lot of time. But there are a few good quality fabric paints available in the market which dries quickly on paper, you can use them on paper without much trouble.