So you have 522 sq. ft. of wall. - That would be adequately covered by 2 gallons of paint. Now all you do is figure out how long it takes you to paint it.
1- Door & Window frames first (and the ceilings if applicable)2- Next the Walls.3- Then you finish off with the baseboards.The reason why it's important to paint the frames before the walls is that it is much easier to cut a strait line with your brush comfortably resting on a wall (compared to the tiny edge of of frame).Now the reason why you don't paint the baseboards first is in 2 part.1- Even if you do a great job cutting in with the brush and not put any paint on the baseboards, you're still going to have tiny drops from when you roll out the wall paint.2- The most important reason for DIY's however is to create the illusion of a straighter line.The logic is simple... unless you are lying down on the floor... you will be admiring the beauty of your new paint job from a higher point than your baseboards. This means that if there should be any of the trim paint touching the wall it won't be as noticeable than having some wall paint touching the top of the baseboards.Test it... and see for yourself :)Happy Painting Everyone!
If it is a light color I would think it would look OK, but it will make your room look smaller. How about one wall in a dark color and a contrasting color on the walls. Make a stencil and put clouds on the ceiling. I did this in my kitchen.
air in the booth enters from the ceiling and exits thru the floor ( the draft is moving down in a side draft booth air would exit thru the walls
Yes, you can. I would use a spray to keep it light.
You probably can. As long as the masonry paint is 100% acrylic, you will have no problem at all using it on a wooden porch ceiling. Using a cheaper vinyl paint is not suggested on wood though as it will craze and crack over time.
1- Door & Window frames first (and the ceilings if applicable)2- Next the Walls.3- Then you finish off with the baseboards.The reason why it's important to paint the frames before the walls is that it is much easier to cut a strait line with your brush comfortably resting on a wall (compared to the tiny edge of of frame).Now the reason why you don't paint the baseboards first is in 2 part.1- Even if you do a great job cutting in with the brush and not put any paint on the baseboards, you're still going to have tiny drops from when you roll out the wall paint.2- The most important reason for DIY's however is to create the illusion of a straighter line.The logic is simple... unless you are lying down on the floor... you will be admiring the beauty of your new paint job from a higher point than your baseboards. This means that if there should be any of the trim paint touching the wall it won't be as noticeable than having some wall paint touching the top of the baseboards.Test it... and see for yourself :)Happy Painting Everyone!
If it is a light color I would think it would look OK, but it will make your room look smaller. How about one wall in a dark color and a contrasting color on the walls. Make a stencil and put clouds on the ceiling. I did this in my kitchen.
yes
air in the booth enters from the ceiling and exits thru the floor ( the draft is moving down in a side draft booth air would exit thru the walls
I think I would go for a lighter colour, because you don't want to put too much emphasis on the ceiling. However, if you want to paint the walls a darker colour, i think that could be a great choice. But in the ends, its up to you!
Yes, you can. I would use a spray to keep it light.
They are placed on the floor because heat rises. If the heater was up high, the ceiling would be nice and warm, while the walls and floor would be cold.They are placed on the floor because heat rises. If the heater was up high, the ceiling would be nice and warm, while the walls and floor would be cold.
rocks, cave walls, the ground. anything sturdy really that would hold the paint
I would use a good primer first.
You probably can. As long as the masonry paint is 100% acrylic, you will have no problem at all using it on a wooden porch ceiling. Using a cheaper vinyl paint is not suggested on wood though as it will craze and crack over time.
Dry latex paint can sometimes be reactivated with water because latex paint is water-based. When water is applied, it softens the paint's surface, making it easier to wipe off. This is especially common with matte or flat finishes that have not been properly cured.
It really depends on what is wrong with it and the extent of the repairs.