connected to the starter
== ==
A way to tell is by the sound the motor makes. If it is winding slowly with no force it could be going out. If it skips or whines without action it is out.
He died at Figueres, Spain, almost 85 years old.
What happens if the polymorphs is 85 % in the blood?
I have a 85 FXWG, Dont know if the set up is the same but it should be close. There are two ways you can go about #1) Remove outer primary and the mounting bolts to the Solinoid then remove the starter, in where the starter bolted to the inner primary casing, there will be a gear that meshes with the gear on the end of the starter shaft. ( when the solinoid is pulled in) It is held in place with 1 or 2 Allen head bolts. (Can't Remember) Remove the Allen bolts and this will allow you to pull out the shaft (from the inside of the primary) that engages your starter to the Clutch. now the Solinoid has a fork that attaches to that shaft and it can be wriggle free as you pull on the shaft and pull out on solinoid at the same time. watch for shims when you pull the outer primary cover and replace them on the stub shaft when you put it back on. #2) Remove the outer primary cover and with care you can bend one side of the fork that pulls the shaft into the clutch, you will see what I am talking about this will allow you to pull the solinoid with out going thru the hassle of pulling the starter. Then when you put in the new solinoid just bend the fork back up enough that it will not fall out of place. The fork is not real easy to bend it will take some doing. Hope this helps
High torque starter
The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.
I'm trying to find out how to hook up the vacuum hoses to the carb in a 85 delta 88. I need to know how they go.
Two bolts hold the starter to the block. There may also be a brace on the other end of the starter.
passenger side, next to oil pan.
Starter relay on 85 glide is located under the seat on the drivers side of the frame. It is circular and you cannot miss the heavy wiring running to it from the battery.
To find 85% of something, multiply that something to the decimal equivalent of 85% which is 0.85. Example: Find 85% of 100 = 0.85 * 100 = 85
The starter will cost you around $85. The labor will be another $75.
== ==
How to calculate current of star and delta moter with 55kw 380v 85%
A tiny 2-prong junction box on the firewall. one wire comes to it from the Ignition, & the other wire goes out from it to the starter. If you take a jumper wire from the positive on the battery & touch it to the post on the junction box where the starter wire comes out, with the key on, It should start the truck. If it doesn't, you need a new starter.
If you divide 75 by 100 you can find 1%, which is 0.75, then you simply multiply it by 85 to find 85%, which is 63.75