I have a 2004 Honda Accord Coupe and I recently was asking myself the same question. Your car should be very similar to mine. So I got under the car and located what looks like a good place to jack the car up. Once you get under the car you should notice the frame rails on both sides of the car front and back. I plan on placing a small block of 2*4 wood between jack and frame rail. This will allow for a smoother operation. Your going to have to fix the location of the floor jack so you can crank the handle up and down to raise the car. If you have any experience using a floor jack this should be a relatively simple procedure.
Yes.
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
Traction Control System (TCM). Just leave it on all the time.
It is under the dash near the steering column.
1. Turn the ignition switch to the ON (II) position. 2. Press the select/reset knob a couple of times until the engine oil life indicator is showing. 3. Press the select/reset knob for about 10 secs. The engine oil life and the maintenance item code will blink. 4. Press the select/reset knob for another 5 secs. The maintenance item code will go away and the engine oil life reading will reset to 100. Same for Honda Accord 2009
The 2003 Honda Accord OBD 2 port is under driver side dash above dead pedal
Where does freon go in a 2003 Honda accord
The 2003 Honda Accord has 16 valves.
how do you replace the radiator on a 2003 V6 Honda Accord
The 2003 Honda Accord is a gas-powered vehicle.
The 2003 Honda Accord has a 5-speed manual.
The 2003 Honda Accord has an inline 4 engine.
WHERE IS THE FUEL FILTER LOCATED ON A 2003 HONDA ACCORD
The height of the 2003 Honda Accord is 4 ft. 9.1 in. (57.1 in.).
The 2003 Honda Accord is 15 ft. 9.5 in. (189.5 in.) long.
The 2003 Honda Accord has a drag coefficient of .30 Cd.
The 2003 Honda Accord runs on regular unleaded.