What engine? Find the serpentine belt. One of those pullies is the ac compressor. Check for a couple of aluminum lines going the back of one of those components as well as and electrical plug and you found it.
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
It will bolt up to the engine, but the cross member will not work as the 400 is longer than the trans. in the 86. You will also need to make a down shift switch as the 86 trans. has a detent cable, the 400 has an electric switch. There is also the driveshaft issue.
Yes. Look in the yellow pages for aftermarket a/c's
yes
Back side of the engine block, on top, behind the intake manifold, just to the driver's side of the distributor.
On the bottom of the engine.
Inside the oil pan mounted to the engine block.
Quick release fitting located on the low pressure side (Larger hose from compressor)
Inside the oil pan mounted to the engine block.
It is normally where the upper radiator hose meets the engine block.
were is the bcm located on a 2000 monte carlo
On a 2000 Chevy Monte Carlo it is along the frame rail on the drivers side
Interference engine.
It is the belt driving the water pump, power steering pump, alternator, & A/C Compressor. I think on this engine it is located on the passenger side front of engine.
Depends on what engine and what year Monte Carlo you're referring to...
The 1995 Chevrolet Monte Carlo cooling fan sensors are located on the firewall, in the engine compartment. The cooling fan sensors will be on the passenger side of the firewall.
No. It only has one compressor and it is bolted to the front side of the engine.