On any motor, the harmonic balancer is on the front of the crankshaft. It is what the pulley is bolted to.
That balancer requires a 3-jaw puller to pull it off, just be sure you have the claws on straight, and if it gets too tight to turn the end of the puller, tap on the end with a hammer, then turn some more.
Yes, there is a diagram of a 1992 Toyota Corolla Engine. This diagram can be found in the cars specific maintenance manual, found in auto part stores.
Dexron 3 automatic transmission fluid, same for transmission/differential 3 speed transaxle 2.6 qts 4 speed transaxle 3.3 qts manual 2.7 qts 1999 1.8L Corolla Haynes Repair manual.
The exhaust system on a 1996 Toyota is located underneath the vehicle. This system runs all the way from under the motor to the very back of the vehicle to the muffler.
Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.
On the harmonic balancer that's attached to the front of the cranck shaft
The harmonic balancer is located on the front of the crankshaft
The 1996 Toyota Corolla does not have a cabin filter.
where is the starter relay switch on a 1996 Toyota corolla
No
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA
loosen the center bolt and get your self a harmonic balancer puller just make sure you loosen the center bolt enough but not too much but you need a balancer puller.
check harmonic balancer. check harmonic balancer.
yes they are the same cars from 1992 to 1997
lug pattern on a 1996 corolla is 4x100
no its not i paid 50.00 dollars for balancer and put it in about one hour
The thermostat in a 1996 Toyota Corolla DX is located in the top radiator hose. It is in the end that is closest to the engine.