Where is the PCV valve on the 2003 ford sport trac?

Answer 1

It is toward the rear of the driver's side valve cover. If you notice that the intake plenum kind of hangs over the valve cover a lttle bit. the PCV is at the end of a short vacuum line, under the edge of that overhang, toward the rear.

Answer 2

Standing in front of the ranger, approximately where the radiator cap is - follow it straight back, it's plugged in just underneath the right back side of the manifold. (you have to squat down to fender level to see it)

Answer 3

On the drivers side of the engine look below the #2 spark plug, if you get up on the engine you can look down past the plug you can see the top of the PCV valve. It is at the end of a black hose that is visible between the intake manifold for the #1 and #2 cylinders. Reach under the manifold and pull straight up on the valve, it will slide out of the rubber grommet. Remove valve from hose and replace with new unit. Slide new valve into grommet all the way to the stop on the valve. Good luck, Rob

Answer 4

Passenger side, valve cover, under the air intake hose, the ribbed hose. Make sure you check the hose too, mine had a hole in it making a crazy squeaking noise.

Answer 5

The PCV valve on a 1993 F150 is located in the top of the valve cover. it is a plug in type, and is easily replaceable.

Answer 6

It probably doesn't have one. Most newer cars are not using them anymore, they are venting it by other means

Answer 7

its located in the valve cover