If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
when you start the car up that's your ignition switch is located...
Backfiring in any motor is either badly out of time or a burnt valve.
It is at the rear of the intake manifold, follow the heater hose. there is a flow door under the dashboard with a cable connected is that the control or does the valve body at end of intake still control it?
if you have to ask you won't be able to do it by your self a 302 or 351 will fit but you will need a 302 powered thunder bird for parts
If not working or defective - you can't start the truck. It cuts off the fuel pump. Will it work and cut off later in a crash situation? LoL
The bleeder valve for fuel injection for 1986 Nissan 300ZX is located at the furthest end of the fuel rail.
screwed into back of intake,behind carb.
what is valve of ford truck F150 1986
Nissan Hardbody Truck was created in 1986.
theirs a vaccum line coiming from the egr valve,going to the btp valve on the back side of intake manifold,by back fire wall.
If it's a ka24e it's somewhere on the block.on most cars it right on top of the valvecover.so goodluck
need diagram for 1986 Nissan truck alternator
they wont change out
The EGR Valve is located on the intake manifold.
below the right side of carb.
it's not hard
1324