it is at the back of the motor there is a slot in the transmission top side it reads off the flex plate that the covertor bolts to On an automatic trans equipped truck it is under the trans dipstick behind the right cylinder head.
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
Trouble code P0016 means: Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor A Trouble code P0034 means: Turbo/Super Charger Bypass Valve Control Circuit Low
the lamba sensor is located inside the maifold
I had this problem with my 2001 Tracker, 2.0 L DOHC engine. The problem was caused by the Crankshaft Position (CKP) sensor. It wasn't sending the right signal when it got hot. Info on the web said a guy doused it with water after it got hot enough to affect the engine and it started right up. Replacement was about $180 for the part. Easy install. Problem solved.
theres a big plastic box inside the dash that controls the vent options for the truck.. this is common in dodge rams, the plastic tabs on the blend doors (blends air from inside, outside, hot and cold) break, and get stuck in a certain position
There definitely is a crank position sensor on a Neon
Look at the crankshaft pulley, it is right there.
where is the crankshaft position sensor on a 2003 monte carlo
how to replace the crankshaft position sensor located in a 2003 kia rio
if it is a 2.4 "x" motor, the crankshaft position sensor should be located in the front of the motor "TUCKED" up behind the starter. it is very difficult to find, but it s there.
Right by the oil filter.
Crankshaft sensor intermittent. Or crankshaft circuit intermittent.
behind the oil filter
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine It is positioned and bolted into a machined hole in the engine block
How do you change the crank sensor on a 2002Nissan Atima3.5?
where is the crankshaft position sensor a bank 1 circuit malfunction on a 2003 f150 at
Try checking for the crankshaft sensor