answersLogoWhite

0

how to replace the crankshaft position sensor located in a 2003 Kia rio

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the crankshaft position sensor on a 2003 Monte Carlo SS?

where is the crankshaft position sensor on a 2003 monte carlo


Where is this located on the 2003 f150?

where is the crankshaft position sensor a bank 1 circuit malfunction on a 2003 f150 at


Where is the crankshaft position senor located on a 2003 Cadillac deville?

where is the 2003 Cadillac Deville Crankshaft Position Sensors located


Where is crank position sensor on a 2003 Chevy cavalier?

The crankshaft position sensor is located behind the starter on the front of the engine. Hope this helps! Mitch art_y2k1@yahoo.com


Where is the crankshaft position sensor located on a 2003 Cadillac CTS?

On the back of the engine right below the windshield wipers


Location of crankshaft position sensor 2003 Saturn L200?

The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.


Where is the crankshaft position sensor on a 2003 dodge stratus 2.4 liter?

if it is a 2.4 "x" motor, the crankshaft position sensor should be located in the front of the motor "TUCKED" up behind the starter. it is very difficult to find, but it s there.


Where is the crankshaft position sensor located on a 2003 Chrysler Town and Country 3.3?

It is on the top rear of the transmission bell housing.


Where is crankshaft position sensor on 2003 JETTA?

Right by the oil filter.


Is there such part on 2003 dodge neon crankshaft sensor?

There definitely is a crank position sensor on a Neon


Where is the crankshaft sensor located at on a 2003 internationl dt466?

On the engine.


On a 2003 dodge durango that has a 4.7 liter engine in it where is the crankshaft position sensor located at?

The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine It is positioned and bolted into a machined hole in the engine block

Trending Questions
How do you replace the driver side seat belt receiver on a 2006 jeep grand Cherokee Laredo? How did fixing bad ground wire on running lights passenger side for 2000 Chevy S-10 affect brake lights. Now the drivers side ONLY brake light goes off when apply brakes.All other lights seem work OK? How often to change spark plugs in 2011 sonata? What could be wrong if the battery is good and the alternator is good but the battery keeps being drained? How do you check the brake lights on a semi truck when you're alone? How does antifreeze affect the freezing point of water? Can you use a water hose to wash off your engine? What is the firing order for 1993 must gt 5.0? Is it bad for your car if new brake pads squeak? Water heater flame goes out when you release reset button? What type of brake fluid do you use for a 1995 Vauxhall Corsa Breeze? I have disconnected the air intake pipe from the air filter box will this bring more air into the filter system and make the engine run and sound nicer? How do you replace map light switches in overhead console of dodge ram? Where do you pu transmission fluid in 2005 ford xlt? P0446 Evaporative emissions control vent circuit? What happens if you accidentally swallow a mouth full of antifreeze? Where is the heater fuse for a Chevy s 10 located? Where is the turn signal relay on a 1999 Mitsubishi eclipse? How to change transmission fluid for 2001 dodge neon? What is the gap setting on Briggs and amp stratton spark plug for 6hp engine?