The coolant temp sensor is the two wire sensor located near to where the upper radiator hose hooks to the engine.
If you don't have fire at the plug, change the crank sensor first, then the coil.
lots of strain on the engine i would imagine..
There are to oxygen sensors on a 2004 Chrysler Sebring. They are located on the right side of the engine, against the firewall. Sensor 1 is located in front of the catalytic converter, and sensor 2 is located behind it.
The 2004 Mitsubishi Evolution fuel temperature sensor can be found on the top of the gas tank. The fuel temperature sensor will be near the front of the gas tank.
It is on the starter.
The fuel pump on a Chrysler Sebring is inside the fuel tank.
The 2004 Chrysler Sebring fuse box is located in the engine compartment. The fuse box will be on the drivers side behind the battery box.
No reset switches on Chrysler products.
2004 CHRYSLER SEBRING COUPE = 4.6 Qts W/Filter 2004 CHRYSLER SEBRING SEDAN = 5 Qts W/Filter Hope This Helps.
It is under the dash on the far passenger side.
It is under the dash on the driver side.
Idle is computer controlled and is not adjustable. If the speed is incorrect there is a sensor or actuator malfunction.
There is no sensor three on this car. Sensor one is pre catalyst, sensor two is post catalyst.
behind the top rear seat
No.
It would be very expensive considering that car doesn't have a carburetor.
The crank sensor is located under the car near the exhuast. If you have the replacement you'll see it easy.