it is beyond the main throttle body. it is round about the size of a tangerine. it is black on my car.
Assuming you mean the egr valve, I would make sure that you have the check engine codes cleared. In addition, are you sure that it was truly the egr valve, and not the DPFE sensor monitoring the valve?
how can i delete a egr vavle on 1997 ford f350 with electronic fuel injection, its a7.5 gas 460
The 2004 Dodge Durango EGR valve can be found on the firewall in the engine compartment. The EGR valve will be on the passenger side of the firewall.
The EGr valve can be difrent and is in difrent locations on the various engines
Check the EGR valve. It sounds like your EGR valve is staying open. An EGR valve that is open at idle will cause a car to stall. An EGR should be closed at idle and open when you are driving around.
Contact your dealer.
How do you replace the EGR Valve on a 2001 Ford Escape?
location and replacement of pcv valve and egr valve on 2005 Ford Taurus se
just unbolt the valve
This issue is typically caused by a broken or jammed EGR (Exhaust Gas Recirculation Valve). To remedy the problem, you must remove the old EGR valve and replace it. Attached is an Article from AutoZone on how to determine if it is the EGR valve and how to replace the EGR on a Generation 3 (1996-1999) Ford Taurus, It will also determine if your problem lays in other EGR components.
If you can find the EGR valve you'll see a wire connector/plug on top of it...that's where it is. It can be replaced by unplugging the wire connector and removing the small screws that fasten it to the EGR valve It is usually called an EVP (EGR Valve Position) sensor.
yes 2002 and later 30L are the only ones not equipped with an egr valve
ther always next to and wired in to the egr valve on intake manifold
do you have the 3.0 V6 12 valve engine, or the 3.0 V6 24 valve DOHC engine? 3.0 v6 12 valve
The 2002 Mercury Mountaineer EGR valve can be found in the engine compartment, on the firewall. The EGR valve will be labeled as such.
Should be located on the intake manifold.
Should be located on the intake manifold.