answersLogoWhite

0


Best Answer

The solenoid is on the left hand side facing the engine underneath the block. There are only 3 bolts to change it out and u need to do it from underneath the car.It's right next to the where the transmission connects to the block. good luck

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the solenoid on a 93 Dodge Caravan and how do you change it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Why wont your 93 dodge stealth start turns over no start and it does not have a crank cencor do you need this?

If the 93 Stealth came with a crank sensor but it does not have one now, then it will not start. The sensor shows the ignition coil when to send power to the spark plugs.


What size Allen wrench is used to change the brakes 93 Bonneville?

I think that one is a 3/8 Allen.


Starter wont disengage when you start 93 ford ranger.changed 2 starters and solenoid.where to go from here?

I'd check two things: I don't remember what year Ford changed over, but if yours still has the starter solenoid on the fender, make sure you haven't crossed the small wires. If the solenoid is on the starter, are you certain that you've wired the starter right? There are a couple small wires that connect to the starter,if you connect them wrong it could the cause problems you describe. If you're CERTAIN that the starter and/or solenoid are connected properly, start looking seriously at the ignition switch.


How do you wire a 93 dodge 5.9 cummins alternator into a 78 ford?

The alternator on a 1993 Dodge is regulated by the engine computer. You would have to find an aftermarket regulator and follow it's wiring schematic.The alternator on a 1993 Dodge is regulated by the engine computer. You would have to find an aftermarket regulator and follow it's wiring schematic.


How on a 93 dodge spirit 3.0L how do you check to see if the starter relay is bad?

from what ive read you can switch the starter relay with the horn relay and give it a try.... if she starts and the horn dont work you have a bad relay