The thermostat for the cooling system can be found on the front of the engine. You can follow the bottom radiator hose to the thermostat housing. The thermostat will be within the thermostat housing.
Which model is it, year etc. on a 95 pug 306 XL 1.4 its quite difficult to get at ( im trying to change mine now) if you look at the rocker cover (top of the engine) its towards the cockpit at the back of the engine on the right. an easier way to find it is to follow the leads off of the battery one should go behind the engine and to the starter
The 2003 Subaru thermostat is located inside of the thermostat housing, on the front of the engine. The thermostat will be near the bottom of the engine.
Drain the water from your radiator. Remove the radiator hose, from the thermostat housing. Remove the thermostat housing retaining bolts. Replace the thermostat housing gasket and reverse the process to install the new thermostat.
15.00. for gasket and thermostat
Drain the water from the cooling system. Remove the radiator hose from the thermostat housing. Remove the thermostat housing retaining bolts. Reverse the process to install the new thermostat.
If by S16 you mean a Phase1 S16, then it is right above the throttle body, but on the other side of the bracket, right next to the cylinder head, with a plug on top of it. You can trace it from the TB as there is a hose running to it from the upper part of the TB housing.
really easy fix! what model 306 is it? regards, Simon
Normally located to the right of the steering wheel. It is a numeric keypad.
with a complete standard pug 206 you should be able to do around 20 miles fine, anything over will be pushing the petrol gunk into your tank.
There is a TDC sensor on the front of the gearbox bell housing of most 306 Diesel models (up to MY '99 I believe) Neil
S16
Go to a gunsmith
A Peugeot 306 that has a noisy fan and overheating may need a fan replacement. One may also look into the coolant or thermostat to resolve the issue.
I am pretty sure the thermostat is on the lefthand front of the engine about half way down the motor. It has 1 wire leading to it and a wire clip over the connector. You need a 22 mm diameter long socket spanner to remove. If this is not the thermostat I'm sure some expert will correct me.
pug diesel turbo r good for 150,,,170 thousand miles... The above answer is mad I bought my partner a pug 306 D its done 130,000 miles I dont know for sure if its ever been replaced but it was in serious danger of snapping when I checked it. A manual for this car will state a chgange every 72000 miles max but recommend every 36,000miles. Using the above advice im sorry is dangerous. I hope this helps any doubt refer to the Haynes manual.
It won't be back
A 1996 Jeep Cherokee.