0
What else can I help you with?
What changes do you need to put a 440 engine in a 1973 dodge dart that us to have a 318?
you can bolt the engine in place with motor plates and then you will probably need to make a new cross member for the 727 transmission to mount and of course you will have to have a new drive shaft made.
Which vehicle has a 53 inch drive shaft center to center of the drive shaft U-joint?
98 chevy s10
What length is the drive shaft for a 1969 dodge dart swinger with the 340 and 4 speed?
51.53 inches from u-joint center to u-joint center
Can you drive without the camshaft sensor?
The engine will not run without a cam shaft sensor. The sensor is necessary for the electronic controls to adjust timing and fuel being sent to the engine depending on the power it requires.
How do you replace the rear drive-shaft on a 96 tacoma reg cab?
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
Dodge Durango rear drive shaft removal?
How do you remove drive shaft from a 03 durango
When do you change the transmission on a 2006 Dodge Durango?
The transmission on a 2006 Dodge Durango is changed by removing the drive shaft, disconnecting the linkage, and unbolting it from the engine. It can then be lowered from the vehicle and replaced.
What grease is required for drive shaft on 2002 dodge ram 1500?
The front drive shaft did not have any grease zerks from the factory.
Replacing front drive shaft On a 1994 Dodge Ram 1500 4x4?
front drive shaft, how do you get the yoke out of the transfore case to replace the ceal?
How does a car drive shaft operation?
when the car engine is start and the driver shift a gear,the power front the engine transfer to the drive shaft and its transfer the torque or power to the axle shaft the move a wheel.
What is a vertical shaft engine?
Drive shaft is vertical- like a lawnmower. Cylinder is horizontal.
What does a drive shaft typically do?
A drive shaft is found in a frnt-wheel drive vehicle. It runs from the engine and gearbox to the front wheels. The engine generates energy, known as torque. The drive shaft carries the torque to the wheels forcing them to rotate, thus moving the vehicle.
What is the purpose of a dry shaft in a car?
there is no dry shaft oly a crankshaft in the engine and the drive shaft that moves the car the drive shaft is connected to the transmission and the rear axle if your car is front wheel drive ypu do not have a drive shaft just a transmission and two axles
How do you replace a drive shaft center support bearing on a 2006 dodge ram megacab?
You must remove the rear drive shaft section and then remove the support.
Do you put a dodge Dakota in neutral after dropping the drive shaft on a tow dolly?
if you have removed rear drive shaft and the front wheels will be on tow dolly then there is no sense in it.
How do you change a 3.9L to a 318 in a Dodge d150?
Eng,trans,drive shaft
What car make has no drive shaft?
None. Every engine has a drive shaft, which connects to the transmission, and ultimately causes the wheels to turn.
