Fuel pump gone bad? Relay stuck? Ignition module fried? Only two things will keep an engine from starting. Lack of fuel or lack of spark. The first step is to determine if spark is present by detaching a plug wire and carefully inserting a screwdriver or the like into the end and placing close enough to the engine block (metal) without touching it (1 inch or less) for a spark to jump. Have someone crank the vehicle and look for spark. If no spark then you have found the culprit. Bad coil or ignition module. CAUTION! You can get quite a jolt if you handle the wire while the car is being cranked. If you have spark then you need to determine if you have a working fuel pump. One method is to have someone turn the key from the off position to the run position (the position where the engine runs {just before the crank position}) a few times while you listen as closely to the fuel tank as you can get. You will hear the buzzing of the fuel pump if it is functioning. The other method is to locate the fuel line pressure hookup (it will be on the fuel rail. a valve not unlike a tire valve only larger) and depress the valve stem. It WILL SHOOT FUEL AT YOU. SO BE CAREFUL. Once you have done this cycle the key a few times and then depress the valve again. If it spits at you again the pump is circulating fuel, if not then the pump is not functioning. Y-THINK-Y Well i would check the spark at the plug first. You have to eliminate spark and fuel problems. If you turn the key you should hear you fuel pump engage. That doesn't necessarily mean that it's working. Once you know that the fuel is getting to the motor there are 3 things that I would check. 1. Crankshaft sensor (located on the transmission housing) 2. Camshaft indicator (located on the side of the block) 3. Ignition coil. (where all the plugs come from) The first two provide information to the PCM and if it doesn't get it the van will not start. It would help if I knew what year and model'engine size ----------------------------------------------------------------------------------- I certainly agree that these other sensors can be the cause but unfortunately to determine the source of problem beyond the simple spark or fuel tests it is best to have a diagnostic computer because there is so many little telemetric devices that will effect the computer that one could spend many, many hours and dollars replacing them one-by-one. This is when a pro should come into the picture. POST: It is my experience that an engine will not 'crank' at all if the crank sensor is bad. Y-THINK-Y
cold cranking amps is the rating on a car battery- the higher the number of cca the stronger the starting power of the battery
Using the electronics (lights, radio, cranking engine but not starting, etc) without charging the battery. If you charge your battery, the car starts and runs, but goes flat in a short amount of time, it's possible your alternator is not working properly.
only the older belt driven air pumps seize up and may stop engine from cranking by fan belt holding engine, new electric air pumps are prone to suck up water or electric motor failure causing fuse to blow but car will still run
It may be a bad battery, jump starting usually works by attempting to assist the battery, if the battery is no good, jump starting may not help. If it turns over (the engine) you can try holding down the gas while cranking, or spraying 'starter fluid' into the intake prior to cranking the engine. It may also be that the starter motor is bad, and therefore not able to turn the engine over. It may be unlikely, but the engine could be flooded as well.
Car names starting with L include: Lincoln, Lamborghini, limousine, Le Car...
this question makes no sense ? i assume you mean prevent the car from cranking??? if so then no. a bad fuel pump may stop the car from running or starting but it should not stop it from cranking. a bad fuel pump relay could stop the car from cranking but that would depend on the year make and model of your car.
cold cranking amps is the rating on a car battery- the higher the number of cca the stronger the starting power of the battery
Cranking the car or starting the car in cold weather can wear out a car battery. You can also wear out the battery by turning the starter over without fuel in the tank.
Dirty battery connections created a spark when cranking the starter on a possibly overcharged/overheated battery causing an explosion.
replace the distibuter
NO.
Amps are just a general measurement of electric current in any application, whereas the term cranking amps are specific to automotive / starting battery applications. Cranking amps is a measure of the maximum current a car/ starting battery can produce in normal temperatures for 30 seconds before the battery voltage drops too much.
check battery and alternator
1) the vehicle is upside down 2) ownership has changed 3) common term describing cranking, or starting the engine
If it's not cranking at all, it could be the keyswitch, a bad connection somewhere, the starter or the neutral lockout switch.
no
Weak battery