answersLogoWhite

0

The fleet of vehicles where I work have many S10's and Sonoma's 2 wheel and 4 wheel drive. The front end steering and suspension parts I see wear out the most are the idler arm and pitman arm joints on both 2 wheel and 4 wheel drive. On the 4 wheel drive the lower ball joints wear out fast. I also see the upper control arm bushings on the drivers side go bad from the heat coming off the exhaust manifold.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why is the steering loose on my 2000 GMC Safari?

Because youneed to grease it or you need new frontend parts.


Where do you put freon in at on a 2000 gmc jimmy?

where do you put freon in on a 2000 gmc jimmy


What type oil 2000 gmc jimmy 4.3?

What type of oil for a 2000 GMC Jimmy


Where can you find a steering column diagram for a 1989 GMC Jimmy?

You can find a steering column. Diagram, for a 1989 GMC Jimmy, at most GMC dealerships. You can also find the diagram at most auto-parts stores.


Where do you put the power steering fluid on 1994 gmc jimmy?

Power Steering pump reservoir.


Are hoods to a 2000 gmc jimmy compatible to fit a 2000 Chevy blazer?

Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.


Why would the ext temp overhead console and clock not function but then come on mid-drive in a 2000 GMC Jimmy?

sounds like it could be a loose connection.


What is the curb weight of a 2000 GMC Jimmy?

about 4,200 pounds


What type of transmission is in a 2000 GMC Jimmy 4X4?

automatic


'2000 gmc jimmy no floor heat but has defrost and vent heat'?

my 1998 gmc jimmy has no floor heat but i have defrost and ven heat


Location of fuel cutoff switch 2000 gmc jimmy?

Some vehicles are not equipped with a fuel cutoff switch. A 2000 GMC Jimmy is an example of a vehicle that does have a fuel cutoff switch.


Where is the starter located at on a 2000 gmc jimmy?

My 2000 GMC Jimmy is slow cranking. The battery voltage meter is showing charged so I am assuming that the starter is the problem. Where do I find the starter to remove it?