check the starter what year is it , if the key has a transponder chip and you are using a dup made at a wallamrt it won't work.
If you had the key made and it doesn't have a chip that would probably be the problem or your old key is has a bad chip.
1. Does the fuel pump relay click on at all?
Something to do with Alarm or Security... Something to do with Alarm or Security...
You probably need to replace the fuel pump, I had this problem before my engine would turn over but just would not start. The problem was I wasn't getting any fuel to the engine.
Things to check: 1. spark, 2. crank sensor, 3. fuel pressure, 4. pcm codes, 5. fuel pump filter, 6. Inertia cut off switch, 7. fuel pump regulator.
M.Swick
Engine needs a good battery, fuel, compression and spark to run. You are missing one of those.
Fuel?
Spark?
key wont turnthe ignition
If the battery is good and the starter is good, then you must have a wire disconnected somewhere.
Same thing happened to my 94. Turn your ignition to the on position and take a screwdriver and bridge the two terminals together on the starter. If it turns over it needs a new ignition switch. Good luck on that. They are a pain to replace.
not sure if it's the same on yours but on mine this is what i do. i leave the key in the ignition, i turn the ignition all the way back as far as it will go, tap on the key inwards and then try it again. on mine it's because my keys are worn down, yours might be the same, but it's worth a shot.
2002windstar wont start with remote with out key in ignition
Turning my ignition on and wont turn off because it is faulty.
ford transit wont turn over ignition light and battery light on
Very carefully.
key wont turnthe ignition
its either the starter or your ignition
change ignition switch and/or tumbler
Check power from your ignition, and power at the starter
Actually what is the question?
turn key over turn key over
put the kay in the ignition and then turn the car on then turn the wheel. im ean its not rocket sciene...BIG HAIRY
because its to cold
will the key turn at all,the pin cant be pushed in if key wont turn.if key dont turn you will have drill pin