crank sensor is bad
several could bes. If there is no action, the engine does not turn, the rod running from the key switch to the ignition switch on the column could be broken, or the ignition switch itself could haved malfunctioned. If there has be work immediately privious to the problem, check for loose connection, expecially on the ignition switch.
maybe under the front seats
needs either a new ignition switch or a new starter solenoid
Check fuel pump,filter,relay switch,fuses,etc. or spark plugs,wires and distributor cap.
first i would check your coil, if its good, check your ignition switch.
It will get heated and start to glow.
It's a Saturn..
My 95 Saturn sidid that....turns out when the starting got hot it would not function properly
ok i have a 1986 jeep cherokee it wont start from the key in side it turns over but dosent fire up an its got (gas an fire) it will start if you pull start it an it has a carb
well raichu dosent turn into anything.But pikachu turns into raichu
Are you saying that the starter motor turns but dosent engage in which case new starter motor or is there something you've missed out. Help us guys to help you by being more descriptive please.
check your fuses check ignition switch
an ignition switch or starter is a switch that activates the main electrical systems of a vehicle. This normally powers the start motor that turns the engine in the starting up process. . Most vehicles do not have an ignition switch anymore the key in the cylinder acts as the "switch"
In most cases, the engine will not fire or start if the clutch switch is bad. The key will turn in the ignition but there will be no turn-over or sound from the engine. If the engine turns over but doesn't start, there might be a problem with the fuel supply.
No. If the starter turns over the ignition switch is good.
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
Yes. The composite/plastic tips crack. This in turns causes the wire connection to corrode. Replace it with an updated brass tipped version from saturn. Clean the connection or replace it if neccessary. It is also availlable from saturn.