0
It does depend on what kind of paint and how deep it has set in the concrete, but it certainly sounds like a good start to work on.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you clean a stain off concrete?
OK, that is stamped concrete. things you don't want to use are a pressure washer. It will blow the release color off the concrete and destroy the area you are trying to save. first you will want to remove any sealer on the the affected area, you can do this with xylene (you can get it right at home depot) this won't hurt the concrete or the color, and will re liquify the sealer (if it is a topical sealer) once you have use the xylene clean the area with denatured alchohol to remove any residule sealer, once you have done that scrub with a non caustic cleaner such as simple green. if the stain still remains your best option is to contact somone experienced in concrete and have them remove the small stained area and replace it. I did stamped concrete for years so i know what i am doing with this. if i saw this i would do the things i said and if it didn't ome clean i would use a grinder to remove the small section that is orange and then repour it using a high psi mix hand tinted (id mix and pour samples at home first to verify the correct color to concrete ratio) and then just use a small edge stamp to redo the texture.
Which brand of non slip paint would be the best to use on a basement floor?
There are a lot of choices of paint brands you can get. The best known non-slip paint would be Epoxy or Sure Step. You can buy both of these at your local Home Depot.
How do you remove epoxy paint off a car?
Removing epoxy paint off a car can be a tricky task, but with the right preparation and proper tools, it can be accomplished relatively easily. The first step is to thoroughly clean the car with a pressure washer or a degreaser. This will remove any dirt, debris, and grease from the surface of the car, making it easier to remove the epoxy paint. Once the car has been cleaned, it is important to wear protective gear, such as gloves, a face mask, and safety glasses, before beginning the removal process. Next, you need to use a heat gun to soften the epoxy paint. Heat guns typically reach temperatures between 700 and 1000 degrees Fahrenheit and should be used in small circular motions to ensure even heating. It is important to be careful when using a heat gun as it can easily damage the car’s paint or other components. Once the epoxy paint has softened, it is time to start stripping it off with a scraper. The scraper should be held at a 45-degree angle and used in a back-and-forth motion. It is important to be gentle when scraping the paint off as it can cause scratches or other damage to the car’s surface. Once the majority of the epoxy paint has been removed, you can use a chemical paint stripper to get rid of the remaining paint. Chemical paint strippers contain a variety of chemicals that break down the paint, making it easier to remove. When using a chemical paint stripper, it is important to follow the instructions carefully and wear protective gear, such as gloves and a face mask. Once the epoxy paint has been completely removed, it is important to use a wax or sealant to protect the car’s paint. This will help to prevent any future damage to the paint. Removing epoxy paint off a car can be a tricky and time-consuming task, but with the right preparation and proper tools, it can be accomplished relatively easily.
How do you texture paint walls?
Textured paint is made by adding some inert material to your paint, either while it is still in the can, or by sprinkling it on while the paint is still wet. The most common usage is to give "grip" to painted stairs. An additive known as "Shark skin" - it is really just a fine sand - is added to paint in the can, stirred in and the steps are painted with the mixture. The result is a non-slip surface. The difficulty is that if you do not continually stir the paint the additive settles to the bottom of the can. The best way to use this product is to paint the stairs, wait for the paint to dry, tape or mask off all of the tread but a 1 1/2 inch strip at the front edge of the step, apply another coat of paint and while it is wet sprinkle the "Shark skin" into the wet paint. Remove the tape or masking and wait for the paint to dry. This gives you a a tidier look, a non-slip edge and does not ruin the paint you have left.
Can you turn interior paint into exterior paint?
Interior paint could be used on the exterior with a much shorter lifespan. To extend the lifespan a topcoat to seal it would be advisable. Instead of this two step process, an exterior paint is advisable.
Can you paint concrete slabs?
There are concrete paints available. A three step epoxy paint give a very attractive finish. Both products are available at Lowe's or Home Depot
What should you always do when treating a casualty for heat?
Remove them from the heat is the first step for all heat related issues.
How do you remove concrete from paint?
Removing Paint from ConcreteSome DIY tips from our users:You can get specialist cleaning products from the hardware or DIY store. Try using a Jet Wash (or power washer) as well.I would try using a pressure washer before anything else. Be aware, though, that this method can be damaging to foliage and other surfaces. Remover (stripper) for concrete paint can be found at most local hardware stores and used easily. See the Related link for a step-by-step article (plus photos) on how to use one.
How do you build an external concrete step?
Want to replace an existing subsided external concrete step.
Does a concrete patio step need to be on a footing?
Yes, a concrete patio step does in fact need to be on a footing. Without the proper footing foundation, the step will be uneven.
What is the 1st step for helping a victim that is suffering from high body temperature due to extrme heat?
get them out of the heat n into a cooler room and give them some water and call for help if it is serious and if you are not certified in that area of expertise
Why did the girl paint spots on the staircase?
Becuase she was a step dotter.
Can you change your eye color by what you do?
step 1: take a paint brush and some paint... step 2: shove paintbrush into eye?! I DONT THINK YOU CAN CHANGE IT!!!!!!!!!!!!!!!!
How you separate the components of fruit salad?
step 1. Remove the sala. step 2. remove the fruit. step 3. ???. step 4. profit.
Step by step instructions on how to remove an alternator from a 1991 Chevy step van?
1. find it 2. remove it...? sorry, no idea :/
How do you remove the interior rear view mirror on a 1990 Mercedes 300E?
The first step to remove the interior rear view mirror on a 1990 Mercedes 300E is to heat up the adhesive with a heat gun. Twist back and forth as the adhesive melts and pull the mirror from the window.
Can a step-father have his step child remove from the home?
No
