No, you have to buy the nozzle that will much the pocket hose, you can find it online at eBay, Amazon etc...
when trigger pulled it sucks water from the storage area and dispenses it out the nozzle
yes but you can destroy it I have tried it before
Spray paint is facilitated by passing paint through a nozzle that will break up the paint into particles that can be sprayed onto the surface being painted. The paint is pushed to the nozzle by either hydraulic pressure or by air pressure depending on viscosity. On a hydraulic, or airless sprayer, the fan is formed by the tip itself with a tip only allowing a single fan width and volume. Air spray guns have adjustments to allow for more or less material volume and varying spray widths without having to change out parts of the gun. Pertaining to static electricity: Spray paint works through a process called electrostatic spray painting. The nozzle of the container is negatively charged, and the target is positively charged. Therefore, when the paint is sprayed out through the nozzle, it becomes negatively charged, and is attracted to the positive target, resulting in a paint job that saves paint, gives a smooth surface, and speeds drying.
Yes, that's what I usually do. Pick a nozzle that gives about 6" spray and get all the old paint off.
Tremclad makes it in regular paint or spray. The spray is better, especially if sprayed over a flat white primer they also make.
As long as the hole through the nozzle was the same size for all three, then, yes.
First you put the nozzle were you want to spray and then push the handle down.
nothing
This would depend on what kind of spray nozzle is needed. Any hardware store such as Home Depot or Lowe's should carry various brands of spray nozzles for all of your needs.
The Injector nozzle consists of a needle valve and a series of fine orifices in the nozzle tip. Its task is to inject fuel in an atomised spray pattern and distribute it into the combustion space.
Spiral nozzle is a full or hollow cone spray nozzle,jet angle range can be 30°-180°.flow rates range from 5.5 to 4140 l/min.Spiral nozzle has NPT or BSPT external thread type. Usually 1/4 inch to 6 inch nozzle can be used brass, SS304, 303, 316, 316L materials , as spiral nozzle factory, we sell and manufactuer mutli spiral nozzles.
nozzle
when trigger pulled it sucks water from the storage area and dispenses it out the nozzle
this question is dumb
Not out of a garden hose, but with a nozzle that gives an atomized spray it can.
An atomizer is any kind of nozzle that will turn any fluid into a fine mist, You'd find them on spray-on deodorants, spray paints, hairsprays etc. A fuel injector is a nozzle that turns fuels into a fine mist for combustion.
No, you wont be able to get the nozzle to the baby's throat.