0
You have a 1996 Monte Carlo Z34 tha wont turn over with the keyBut you can take a screwdriver and cross over the starter and it will startbut only for a minute When you turn the key its like a dead ba?
Wiki User
∙ 12y ago
I would suspect a bad starter solenoid that you shorted across. I would use a test light or multi meter to probe the wire leads that go to the starter solenoid and if they test good, replace the starter/ solenoid as an assembly.
more then likely it is you Vehicle anti Theft System..... it says a signal to start your starter and your fuel injectors...... that's why it dies right after
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
The car will not start by the key but all the electoroics come on in the car but if you cross the post on the starter it will run for a minute and die?
maybe the neutral safety switch
1995 Chevy Lumina ignition wiring harness diagram?
the car will not start buy the key but all the electoroics come on in the car but if you cross the post on the starter it will run for a minute and die
Clicking sound when you start your 1999 Chrysler LHS?
My Car did the same thing and at times it would not start, turned out to be my starter was going bad it will cost about 180.00 for a new one and that does not included labor On the 99 LHS the the battery cables often need to be replaced. Try tightening your cables if it doesn't start. Also if you turn your key forward wait a about a minute then crank the engine, if it starts, its your cables. Replace your cables first before you spend the money on a new starter.
What is the normal respirations per minute for an 87 year old?
20 per minute
How many times your heart beat in a minute?
Youe heart beats aboute 100 times per minute.
Why does your 96 Audi A4 not start sometimes then after a minute holding down starter it works?
If it takes a minute for your car to start while holding the key down it sounds like your starter has gone bad. Try replacing the starter.
How do you change starter on a 1996 gmc sierra?
the starter should be on the right side of the engine block there aretwo or three bolts going into the block then the starter should come down a little but on the front of the starter there is a nut holding on wires to the starter i think they are 10mm. once the bolts are out of the block and no wires are on the front of the starter it should come out. its a 10 minute job if that
1994 ford explorer won't start I tried starter fluid it starts for a minute or so what could the problem be?
fuel pumps bad
The car will not start by the key but all the electoroics come on in the car but if you cross the post on the starter it will run for a minute and die?
maybe the neutral safety switch
How many rotations per minute does a car starter turn?
. "The ratio of the number of teeth on the ring gear and the starter drive pinion gear is usually between 15:1 and 20:1. This means the starter motor is rotating 15 to 20 times faster than the engine. Normal cranking speed for the engine is about 200 rpm. If the starter drive had a ratio of 18:1, the starter would be rotating at a speed of 3,600 rpm. If the engine started and was accelerated to 2,000 rpm, the starter speed would increase to 36,000 rpm. This would destroy the starter motor if it was not disengaged from the engine."
Maximum amount of time to engage starter on forklift?
You should only have the starter activated in any type of vehicle for about 15 to 20 seconds at a time. If the vehicle doesn't start within that time period, wait at least one minute before attempting to start it again.
Your 1995 GM jimmy died after driving for a minute Now it won't crank over starter kicks in but engine doesn't turn you replaced battery and starter Any clues what to do next?
My first guess would be the fuel pump is bad. Check the computer for codes and see what it says.
1995 Chevy Lumina ignition wiring harness diagram?
the car will not start buy the key but all the electoroics come on in the car but if you cross the post on the starter it will run for a minute and die
Why does your lawn mower starter get hot?
There are three reasons for it to get hot:Its is bolted to the engine and the engine is hot making the starter hotIt has been used for longer than intended and not allowed to cool properly. !5 seconds max crank time followed by two minute cool down is a good rule of thumbThere is something wrong: Low voltage or poor battery, A bad or poor connection between power source and starter, The engine has a problem causing the starter to work harder than intended or the last possibility is that the starter is faulty and drawing to much power making it heat up.
Replaced your starter And lost your heat?
When i disconnect my battery and reconnect it and then turned my heat on it works for a minute. And then it seems like it makes heat on the driver side and air-conditioning on the passenger side. It has climate control for the passenger.
2001 Chrysler sebring- where is the starter located?
the starter is located between the exhaust manifold and the engine block. It is only visible from the bottom of the car and is protected by a heat sheild.whoever designed this wasn't thinking of the do it yourselfer because the motor mounts will probably have to be removed to get the beast out, or worst.I remember the good out days when a job like was a fifteen minute inconvenience.
When was Minute by Minute created?
Minute by Minute was created on 1978-12-01.
