answersLogoWhite

0


Best Answer

see if theres any current going through the fuse

or just replace the whole horn

User Avatar

Wiki User

โˆ™ 2007-08-02 21:22:50
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

โžก๏ธ
See all cards
1.0
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
1 Review

Add your answer:

Earn +20 pts
Q: Your horn is not working how do you know if you need to replace the fuse or if you have to change the horn?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix the horn on a 1997 Acura Integra?

The horn on a 1997 Acura Integra uses one wire. When a horn stops working it is usually due to a bad fuse. To fix the horn replace the fuse labeled HORN.


Horn is not working?

Check fuse


How do you fix horn in 1999 Plymouth breeze?

You have to replace the fuse for it You have to replace the fuse for it


How do you fix your horn?

if it is out check fuse if fuse is ok you will need to replace it.


What causes the horn to quit working on a 2000 Honda Accord?

Most likely a blown fuse. But, the horn itself can be defective.


Fuse schematic for Ford Explorer?

Horn not working


Why would the horn stop working for a 1995 Chevy cavaleir?

check the horn fuse


Your horn is not working on your 1998 Lincoln Navigator you have located the fuse box inside the vehicle located above the hood release do not know which fuse to change specificly its not marked?

AnswerCheck all fuses and replace any that are not good.There is also going to be a horn relay under the hood. might check that also.


2003 Chevrolet Malibu horn is not working?

look in your fuse panel for a fuse labeled HORN..pull it out and see if it is blown (broken)


How do you change the fuse for the horn in a 2003 Chevy suburban?

The horn fuse is located in the fuse box under the hood on the drivers side of the truck. Lift off the cover of the fuse box and the underside of the cover has a labeled diagrahm. Find the 15 amp fuse. Remove and replace. However, I also have a 2003 suburban and found that the problem originates with a short in the horn assembly in the steerng wheel. The horn will keep working as a lock/unlock indicator, but will only work one time if the horn is activated on the steering wheel. It will keep blowing fuses.


What could be the problem if the horn fuse on a Mercedes 190 blows every time it is replaced?

It seems that you have a short-circuit on your horn circuit. Check to see if the terminals of your horn are touching any part of the cars body. Also see if you can disconnect the horns, change the fuse again, if the fuse holds then replace the horn(s)


Cruise control and horn not working on 1998 town and country mini van Not fuse because horn sounds with remote start?

replace clock spring for airbag in streeing column.

People also asked