answersLogoWhite

0

How do you rewind the rope on the moter

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the gap setting for the spark plug on the Craftsman 32cc line trimmer?

on most trimmers the gap is about 25 thousands !!


Craftsman 32cc line trimmer stop after is hot and not star no more?

Failed ignition, though it could have fouled the plug.


Where can you get an owner's manual for a Craftsman line trimmer?

http://userguides.50webs.com/


What is the gas mixture for the craftsman gas line trimmer 32cc?

2 cycle engine are mixed 40 to 1 ratio. One Gal. of gas to 3.2 oz of oil.


What is the gas mixture ratio for a Craftsman 32cc Gas Line Trimmer?

2 cycle engine are mixed 40 to 1 ratio. One Gal. of gas to 3.2 oz of oil.


Manual for Craftsman 31679116?

Go to Sears.com, then at the top of the page, click on Parts Direct. A box will appear where you can enter the Model #. On the page that comes up, click "View Manual". A .pdf file will open which you can save to your computer.


How do you change the trimmer line on a 5 HP Briggs and Stratton trimmer mower?

craftsman


What is the oil to gas ratio on craftsman 32cc weedwacker?

40:1 is the correct mixture for the fuel and 2 cycle oil. 3 oz. of 2 cycle oil per gallon of gas. I have Craftsman Line Trimmer 358.795190 (Model #). It has the quick release shaft for other attachments. Hopefully this will help you.


The Incredi Pull does not work on Craftsman 32CC weed trimmer. I need to repair so I can start the motor?

The incredi pull design is defective. Obviously there was no quality assurance. The pull line will wear through the small plastic choke idlers and render the entire trimmer useless once it has worn about halfway through.


How do you string a dual line remington trimmer?

It is easy to string a dual line Remington trimmer by following the instructions in the manual. The manual was supplied with the trimmer when purchased.


What spool line do you use on my craftsman 257.798300?

For the Craftsman 257.798300, you should use a .065-inch diameter trimmer line, which is compatible with most standard spool systems. Look for a round or twisted line designed for general use to ensure optimal performance. Always refer to your user manual for specific recommendations or any restrictions on line types.


How do you load weed eater line on a craftsman?

To load weed eater line on a Craftsman trimmer, first, turn off the trimmer and unplug it if it's electric. Remove the spool from the head by pressing the tabs and pulling it out. Cut a length of trimmer line (typically around 10-15 feet), then insert one end into the spool's eyelet and wind the line in the direction indicated by the arrow on the spool. Finally, replace the spool back into the trimmer head and pull the line to ensure it feeds properly.