2 cycle engine are mixed 40 to 1 ratio. One Gal. of gas to 3.2 oz of oil.
How do you rewind the rope on the moter
on most trimmers the gap is about 25 thousands !!
2 cycle engine are mixed 40 to 1 ratio. One Gal. of gas to 3.2 oz of oil.
Failed ignition, though it could have fouled the plug.
To find a fuel line diagram for a Craftsman 32cc line trimmer, you can refer to the owner's manual that came with the trimmer, as it typically includes detailed diagrams and parts lists. Alternatively, you can visit the Craftsman website or contact their customer service for specific diagrams. Online forums and repair websites may also provide helpful visuals and instructions for fuel line routing. Always ensure you have the correct model number when seeking diagrams.
If your Craftsman 32cc Gas Line Trimmer won't run after releasing the choke, it may indicate an issue with the fuel mixture or the carburetor. Ensure that you are using the correct fuel-to-oil ratio and that the fuel is fresh. Additionally, check for clogs in the air filter or carburetor, as dirt and debris can hinder performance. If necessary, clean the carburetor and make sure all components are functioning properly.
40:1 is the correct mixture for the fuel and 2 cycle oil. 3 oz. of 2 cycle oil per gallon of gas. I have Craftsman Line Trimmer 358.795190 (Model #). It has the quick release shaft for other attachments. Hopefully this will help you.
craftsman
The incredi pull design is defective. Obviously there was no quality assurance. The pull line will wear through the small plastic choke idlers and render the entire trimmer useless once it has worn about halfway through.
http://userguides.50webs.com/
To load weed eater line on a Craftsman trimmer, first, turn off the trimmer and unplug it if it's electric. Remove the spool from the head by pressing the tabs and pulling it out. Cut a length of trimmer line (typically around 10-15 feet), then insert one end into the spool's eyelet and wind the line in the direction indicated by the arrow on the spool. Finally, replace the spool back into the trimmer head and pull the line to ensure it feeds properly.
http://www.howtomendit.com/questions.php?id=62&page=1