If it's an average sized rocket, you can make a parachute from a plastic grocery bag. Place a dinner plate upside down and cut or trace a line around it. Cut this circle and attach 4 or 6 x 24 inch pieces of thread to it with scotch tape. Now just tie the loose ends in a knot and attach it to the elastic that goes from rocket body to nose cap. Now your rocket will float down after it's journey into the sky.
The parachute of a rocket is used to slow down the rocket when it falls down.
The parachute creates drag that opposes the rocket's motion, slowing it down. This drag force is generated as the parachute catches the air and creates turbulence, reducing the rocket's speed.
If you have a parachute, then it allows your water rocket to land safely.
For a middle school project, you should design a parachute that is the right size for a small action figure. You can make the parachute out of an old pair of parachute pants.
Rocket Parachute Flare
Rocket Parachute Flare
the parachute was made by Jake parasuit
Same as it is on a human, decelerate the descent speed such that the rocket can be used again.
THe coupler is where the parachute is located and also where it will eject out of the rocket while the rocket is in the air. Written By: Amir Rasuli
Same as it is on a human, decelerate the descent speed such that the rocket can be used again.
typically the nose cone is filled with a parachute to the rocket arrives on the ground safely.
It may unless it has an attached parachute