answersLogoWhite

0

To channel scan an RCA SCST DTV converter without the remote it is virtually impossible unless the scanner has a scan button located on the front. Purchasing a universal remote that works with digital scanners is a good idea.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How can you get channel wnep 16 2?

I have a TV converter box, I use the remote to scan for available signals and then they are automatically programmed into my remote/system as an available viewing channel.


What is the remote code for an sansonic converter box with an comcast remote?

The correct code is tv mode actually toshiba 5102 although does not give any options other than volume & channel up and down and off on I have yet to configure how to retain auto scan options


How do you run channel auto scan on insignia tv with out remote?

To run a channel auto scan on an Insignia TV without a remote, you can use the physical buttons on the TV itself. Locate the "Menu" or "Settings" button, typically found on the side or bottom of the TV. Press this button, navigate to the "Channel" or "Setup" option using the volume or channel buttons, and then select "Auto Scan" or "Auto Program" to start the scan. If your model has a power button, you might need to hold it down for a few seconds to access the menu.


How do you program a 2001 dodge durango remote without an existing remote?

That requires the dealers scan tool.


Why has madani channel finished on sky?

madani channel is on sky, u just need to scan it again. on sky remote - press services, other channels then its as Punjabi channel.


How to run CHANNEL auto scan on westinghouse ld-2480?

To run an auto channel scan on a Westinghouse LD-2480 TV, first, turn on the TV and press the "Menu" button on the remote. Navigate to the "Setup" or "Channel" menu using the arrow keys. Select "Auto Scan" or "Auto Program," and confirm your selection to start the scanning process. The TV will automatically search for available channels and save them once completed.


How can i get my nec to scan chanels?

To get your NEC television to scan for channels, first ensure that the TV is connected to an antenna or cable source. Then, access the TV menu using the remote control and navigate to the "Setup" or "Channels" section. Look for an option labeled "Auto Scan," "Channel Scan," or "Channel Search," and select it to initiate the scanning process. Once completed, your TV should automatically detect and store all available channels.


How do you program a 1999 Chrysler 300m key less entry remote?

Dealer programed, can not be done without scan tool


How do you program a universal game changer remote without code book?

Without a code book, you can program a universal game changer remote by using the "scan" function. Typically, this involves holding down a specific button while pointing the remote at the device you want to program. The remote will cycle through different codes until it finds the correct one for your device. Consult the remote's manual for instructions on how to activate the scan function.


Why receive no channels using digital converter?

If you're receiving no channels with a digital converter, it could be due to several reasons. First, ensure that the converter is properly connected to both the TV and the antenna. Second, check that the antenna is positioned correctly and is within range of broadcast towers. Lastly, make sure to run a channel scan on the converter to detect available signals.


What is the remote code for a zenith DTT901 converter box with a Philips magnavox remote?

I have read 8046 or 8222 but did not gt them to work, purchased a $5.00 universal GE 4 device remote at wal-mart #24944 and using the auto scan on sat it was almost one of the first ones .. and would allow programming so I was able to scan and set channels. Good Luck bc


How do program a keyless remote for a 1999 dodge ram 2500?

With the dealers scan tool.With the dealers scan tool.