answersLogoWhite

0

I have a 04 v-star classic which i have removed the baffels from. I took a hole saw and cut around the small pipe, then welded a bar to the small center pipe and moved it back and forth until the two small welds that hold the pipe in place broke, also if you just want it a little louder you can start by drilling holes around the small center pipe.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you make more sound from bike's silencer?

You can remove the baffles from inside the muffler but the neighbors won't be happy.


How do you remove the driver's seat on a 2007 suzuki 800c intruder?

To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.


How do you remove rear backrest from vw?

how do you remove backrest on a 1994 suzuki intruder 1400


Where is oil plug suzuki intruder 1500 vl?

remove the right side engine cover


How do you gut a glass pack muffler?

To gut a glass pack muffler, first, remove it from the exhaust system by unbolting or cutting it out. Then, use a saw or cutting tool to carefully open the muffler casing along its length. Remove the internal packing material and baffles, leaving just the outer shell. Finally, reassemble the muffler by sealing it back up if desired, or simply install it back into the exhaust system as is.


Can you drill out the baffles on your 2008 883 sportster custom mufflers at the rear of the muffler or do you need a longer narrower drill to drill them out about 12 from the back?

Most Harley Davidson mufflers have "2" sets of baffles. one in the rear and one in the front close to the location where the muffler meets the head pipe. I have found the best wat to remove these is to remove the mufflers, stand them on end on a padded surface ) a few towels will do) and use a piece of galvanized plumbing pipe and a hammer and knock the baffles in until they are flat against the inside of the muffler. But, if you remove the baffles you will also need to increase the flow of gas to the valves or you will burn them out. The Vance and Hines Fuelpack or the Harley CD download ( dealer only) will do the trick. The bike will run so much better once you let it breath. Good Luck


Will a 2006 Suzuki S83 seat fit a 1996 1400 suzuki intruder?

Yes, you just need to remove the center bracket (back seat bracket) on your bike


Where is the fuse box on a 1986 suzuki intruder 700?

my 87 intruder fuses are located inside the left frame cover. i think there is one screw to remove and then the cover pops off.


How do you remove the starter on a 1986 Suzuki Intruder?

To remove the starter on a 1986 Suzuki Intruder, first disconnect the battery to prevent electrical shorts. Then, locate the starter, which is typically mounted on the right side of the engine. Remove the bolts securing the starter, along with the electrical connections, being careful to note their positions. Finally, carefully pull the starter out from its mounting location.


How do you remove the battery on a 1987 suzuki intruder?

The battery box has a bottom hinge. Just remove the 2-10mm bolts, 1 on each side, and slide the battery out the bottom.


Where are the fuses on 1400 Suzuki intruder?

The fuses are located on the left (if your seated on the bike) under the panel that says intruder. You need to remove the seat completely first. you will then find 2 small screws holding the panel in place. Remove them. Underneath there is a small box with fuses written on it.


How do you take off the gas tank on a suzuki intruder 800?

remove the seat and the main bolt is there and look between the handle bars and the tank for the other screw.