0
To remove the starter on a 1986 Suzuki Intruder, first disconnect the battery to prevent electrical shorts. Then, locate the starter, which is typically mounted on the right side of the engine. Remove the bolts securing the starter, along with the electrical connections, being careful to note their positions. Finally, carefully pull the starter out from its mounting location.
What else can I help you with?
What is the spark plug gap on 1986 Suzuki Intruder?
.035
Where is the fuse box on a 1986 suzuki intruder 700?
my 87 intruder fuses are located inside the left frame cover. i think there is one screw to remove and then the cover pops off.
How do you charge the battery suzuki intruder are there charge points located on the bike or must the battery be removed?
1986 700cc SUZUKI INTRUDER how do you get to the battery thank you
What is the oil capacity of a 1986 Suzuki Intruder 1400?
3.7 quarts 3.7 quarts
Where is the radiator filler on 1986 Suzuki Intruder 750 motorcycle?
It is under the chrome radiator cover.
What is the oil capacity of Suzuki Intruder 700?
I have a 1986 Suzuki 700 Intruder and a Fram PH6018 oil fliter does not fit it ... This filter has a 24mm fine thread mount and mine is closer to 18mm fine thread
Where is the oil plug in a 1986 Suzuki intruder 1400?
the 1400 intruder didnt come out till 1987. nevertheless its at the back of the engine right near the battery box.
How much oil is needed to do an oil and filter change on a 1986 Suzuki Intruder?
Take 3 quarts with filter change
How do you change the rear tire on a 1986 Suzuki Intruder?
Lift the rear of the motorcycle, use a tire iron to loosen and remove lug nuts, and remove old tire. Now, put in the new tire, replace the lug nuts and tighten, lower the motorcycle to the ground.
How to repair a leaking head gasket on a 1986 suzuki intruder?
Repairing a leaking head gasket on a 1986 Suzuki Intruder involves several steps. First, remove the engine components that obstruct access to the head gasket, such as the fuel tank, seat, and any attached hoses or wires. Then, drain the engine oil and coolant, remove the cylinder head, and inspect both the head and engine block for warping or damage. Clean the surfaces thoroughly, replace the head gasket, and reassemble the engine, ensuring all torque specifications are followed to prevent future leaks.
How do you changethe starter on a 1986 Mercedes 420 sel?
it is easy if you remove the exhast so you can get to the starter bolts
How do you change starter on 1986 dodge omni?
Disconnect the - battery cable Lift and safely secure vehicle Remove wires from starter Remove mounting bolts Drop starter
