Lift the rear of the motorcycle, use a tire iron to loosen and remove lug nuts, and remove old tire. Now, put in the new tire, replace the lug nuts and tighten, lower the motorcycle to the ground.
how do you remove backrest on a 1994 suzuki intruder 1400
125 front main 140 rear main
Can I use 80/90 luca gear oil
On a 1500cc Suzuki Intruder, the oil fill is typically located on the right side of the engine, near the rear. You'll find a dipstick or a cap that can be removed for adding oil. Be sure to check the owner's manual for specific details and recommendations regarding oil type and level.
Download the FREE Suzuki Samurai Shop Manual from http://www.suzukiinfo.com/ zn
ON THE VS 800 AND VS 1400 THE BATTERY IS IN FRONT OF REAR WHEEL UNDER THE BIKE ON THE VL 1500 TI IS IN THE FRONT ON THE BOTTOM
To change the battery on a Suzuki 800 Intruder remove both the positive and the negative cables from the top of the battery. The batttery and battery box is located low, between the rear wheel, and the frame. You will need to open the bottom of the black battery box by removing two small bolts ,one on each side.Hold the bottom of the battery box as it swings downward when the second bolt is removed so you can lower the battery carefully to the floor. To excange the batterys reverse the procedure outlined.
On the Suzuki Intruder 1500, the oil fill cap is located on the right side of the engine, near the rear cylinder. It is typically marked with an oil symbol and can be accessed easily for topping off or checking the oil level. Make sure to use the appropriate oil type as specified in the owner's manual.
your signal light is burned out. The rear signal lights burn out quite quickly and the fast flashing is an indicator you need to replace them.
most likely the oil tank The tank under the seat is your rear air box for your rear air filter, there is a similar one under the gas tank for your front air filter.
To remove the seat on a Suzuki Intruder 1400, first, locate the seat release mechanism, which is typically a bolt or latch under the rear of the seat. Use a suitable tool, like a socket wrench, to unscrew the bolt or pull the latch. Once released, gently lift the seat from the rear and slide it forward to detach it completely from the bike. Make sure to check for any additional clips or fasteners if the seat feels secure.
Battery is under seat. Remove rear seat first with an Allen wrench then using same wrench remove front seat use Phillips screw driver or 10mm wrench or socket to remove cables from battery. Reverse these directions for installation and assembly.