0
Blend Door Problem
Your problem sounds like the common blend door problem on the Ford Expeditions, and Ford Explorer. The door is on a vertical axis and when it breaks, it can swing back and forth randomly giving heat or AC or nothing. The difference on acceleration is the force placed on the door swinging it one direction.
You can check the operation by fully opening the glove box, removing the actuator motor on top of the plenum box and examining the blend door axle. Pictures of the common fail signature are available on the heatertreater.net web site. There are several "free" fixes that mostly are worth what you pay for them. The solution on the web site is solid and proven over hundreds of vehicles and will resolve the problem once and for all.
What else can I help you with?
What is the average cost for garage door springs repair?
The average cost for garage door springs repair is typically between 150 to 350, depending on the type of springs and the complexity of the repair needed.
Where can you find free Online repair manual for a 1999 ford f-150?
show a diagram to install battery cables on 1999 f-150 ford
How much does it cost to repair 1999 Nissan Altima Tie Rod?
It can cost between $70 and $150 to repair the 1999 Nissan Altima Tie Rod. It will vary based on where the parts are bought and who makes the repair.
How do you repair the power lock on a 2000 Ford F-150?
power lok actuators are located on door latch don't understand repair?
How much does it cost to repair the door over the gas tank?
It's not exact but it's around $98-$150
How do you repair door hinge on Ford E-150?
you get a repair man This is a snide remark! I was expecting some expert assistance and an answer to my question from a professional....guess neither is available.
How do you replace or get a blender door on a 1994 F-150 XLT to go further shut?
Take out the glove compartment box. Behind it, you will see the cable that moves the blender door. It runs through a white gizmo that has a tab on the top. Pull back on the white tab and move the red cartridge to the right one or two notches and release the white tab to hold the red cartridge in place. This takes up some slack in the cable line and closes the air blender door more tightly, thus moving hotter air through the blender box. I found this adjustment works.
How do you repair the blend door motor on a 1998 Ford E-150?
The door motor is replaceable but not repairable. It is probably a vacuum controlled type so make sure that there are no vacuum leaks.
Where do you find a door schematic for a Ford F-150?
you need to find a repair buisnees who has shop key distibuted by snapon tool company. It will give you all the information that you will need for your electrical repair.
How do you repair or replace fuel door housing on a 2011 ford f-150?
To repair or replace the fuel door housing on a 2011 Ford F-150, first, open the fuel door and remove any screws or clips securing the housing. Disconnect any wiring if applicable. If replacing, install the new housing by reversing the removal process and securing it firmly. Finally, test the fuel door mechanism to ensure it opens and closes properly.
How long is a blender a liter or a millimetre?
A blender would be neither. A litre is not a measure of length, and a millimetre is far too small. I would estimate that a blender would be 15-20cm, i.e. 150-200 millimetres.
How do you repair the 1995 f150 blend door?
To repair the blend door in a 1995 Ford F-150, you typically need to access the HVAC system by removing the dashboard and the heater core assembly. Inspect the blend door and its actuator for damage or failure; if necessary, replace the actuator or repair the door itself. Once repaired, reassemble the components, ensuring all connections are secure, and test the system to ensure proper operation. Always refer to a repair manual for specific steps and torque specifications.
