0
remove the brake line from the caliper. press the brake pedal a few times until you notice all the brake fluid in the brake fluid container under the hood is completely drained. put the line/hose back on the caliper. pour brake fluid into the container to required. remove the line/hose once more to remove any air that may have stayed in the tubing. place the line back on once more after you notice the fluid pouring out. (don't let all the new fluid drain out). fill container once more to required. make sure your brake pedal is not too spongey when you press it. this can be a dirty job so don't forget to bring a towel.
What else can I help you with?
How do you bleed fuel injectors on 2000 Oldsmobile alero?
They are self bleeding.
What kind of oil filter do you need 2003 alero?
Oil Filter 2003 Alero V6 3.4L part no. 3387
2003 2.2 alero crankshaft sensor location?
i have a 2003 olds alero i need to know the location of the camshaft sensor
How do markers bleed?
they can bleed if they get to wet or hot or if it breaks and if u press to hard did that answer it
Where is the bleed screw on 2001 olds alero?
By the caliper on top is like a 9 mm
How does dogs bleed?
Dogs bleed the same way people bleed. When they have a cut or any other injury that breaks the skin they will bleed.
How do you bleed brakes on a 2003 Hyundai xg350l?
how do i bleed brakes on a 2003 hyunia xg350
Wiring diagram for a 2003 Alero?
When playing with the electrical system to a car, it is important to have a diagram. A diagram for a 2003 Alero can be found in online forums and in maintenance books.
Where is distributor cap on 2003 alero?
It does not have a distributor cap.
Where is the thermostat located on a 2003 Oldsmobile Alero?
The thermostat is located on a 2003 Oldsmobile Alero in the thermostat housing. The thermostat housing is located on the rear side of the engine block.
When was Bleed the Dream created?
Bleed the Dream was created in 2003.
How to change the antifreeze on a 2003 alero?
To change the antifreeze on a 2003 Alero once the car cools remove that radiator pressure cap. Pour in a gallon of pre mixed coolant.
