answersLogoWhite

0

Minimum Bend RadiusCable TypeFixed

InstallationModerate

FlexCable

TracksUnshielded

Cables4 x Cable

Diameter6 x Cable

Diameter8 x Cable

DiameterShielded Cable4 x Cable

Diameter8 x Cable

Diameter12 x Cable

Diameter

Example:

A 19/C 18 AWG flex cable - .565" diameter - has a minimum bend radius of 4.5 (.565" x 8 = 4.5).

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is bend radius of power cable how can you calculate the bend radius of 3c xlpe 240sqmm armoured cable having diameter of 100mm?

The radius of the curve of the inner edge of the bends shall be at least 6 times the external diameter for armoured cable.


How to calculate power loss in power cable?

The length of the cable is determined by the distance from the center of the distribution panel to the center of the load.


The mean raduis of the earth is 6.3710 to the power of 6mand that of the moon is 1.7410 to the power of 8cmfrom these data calculate a the ratio of the earth's surface are to that of the moon?

The ratio of the surface areas is (earth's radius/moon's radius)^2 where the radii are in the same units.This gives the answer as 13.40, approx.And, incidentally, the word is radius, not raduis!


Could you Calculate cable size for 100 kw load?

To calculate the cable size for a 100 kW load, you would need to consider factors such as the voltage of the system, the type of cable insulation, the ambient temperature, and the installation method. The cable size is typically determined by the maximum current the cable will carry without overheating. Using the formula: Cable size (mm²) = (2 x L x I x R) / (√3 x V x cosΦ), where L is the cable length, I is the load current, R is the resistance of the cable, V is the voltage, and cosΦ is the power factor, you can calculate the appropriate cable size for the 100 kW load.


For 100kw which cable size is good and how to find out cable size?

100 kw is the power drawn by the load. to calculate the cable size you need to know the voltage. From that you can calculate the current. this decides the cable size. for example if the voltage is 400Volts then the current flowing in the circuit when the load is 100 KW will be 250 amps. (100,000/400). for 250 amps to flow with out causing excessive heating of the cable the cross sectional area of the copper cable should be 150 sq mm.for a round cross section the diameter will be roughly 15mm.


While checking the power cable you notice broken insulation What should you do?

Replace the power cable.


The name for the LCD monitar cable?

Its called Data cable. and another cable is called Power cable.


What does curvature of radius of a lens effect?

The curvature of the radius of a lens affects its focal length and optical power. A lens with a shorter radius of curvature will have a shorter focal length and higher optical power, while a lens with a larger radius of curvature will have a longer focal length and lower optical power.


What is the relationship between flow rate and radius size?

Flow rate= radius to the fourth power


If you increase the gauge of a power cable will more energy automatically flow through the cable to the appliance purely based on the fact the gauge of the power cable has increased?

No.


Can data cable and power cable be run in the same rack?

You can do it but what happens is that you might end up getting interference due to the movement of charge in the power cable.


What are some different properties of cable insulation?

Is because of the power rang. The power passing through 6mm2 cable cannot pass through 2.5mm2 cable.