You must remove the serpentine belt first. A tensioner tool makes that easiest. Drain the coolant out, if it is not old it can be used again. Pull the pulley off the pump, use a screwdriver between the bolts to keep the pulley from moving. Loosen all of them first. then Take off the pulley. Remove the bolts, I think there are six not evenly divided out. Only the front part of the pump gets changed and the housing stays on the engine. Clean all surfaces. Use some gasket sealer (blue Form-a-Gasket) in the depression in the pump going around the outside of the pump. evenly tighten the bolts on the new pump. Re-assemble, add coolant, put back on serpentine belt. Done.
The 1990 dodge caravan has a transverse mounted engine therefore it doesn't have a fan belt!
It does not have one.
no only up to a 1990 model
Inside the trans pan.
No , according to the Gates website ( they make timing belts etcetera ) The 3.0 liter V6 engine in a 1990 Dodge Caravan is NOT AN INTERFERENCE ENGINE
Parts for a 1990 Dodge Caravan will usually be second hand, and can be purchased from a breaker or salvage yard. There are also warehouses who specialize in providing parts for caravans and vehicles.
Should be diipstick tube.
Inside of the gas tank.
The grinding noise in the front of a 1990 Dodge Caravan could be a cv joint. If it is, it probably only grinds when you take a sharp turn. There is one located on each side.
Dry fill would be approx 9 quarts, if only filter change approx 5 quarts.
Not likely. The transmissions are different. If you own a 1990, you can use parts from 88 to (I think I remember this correctly) 92.
It is part of the alternator