To change the oil on a Craftsman 6.5 hp log splitter you first need to drain the current oil. The drain plug is on the bottom of the engine crankcase. Once drained, replace the drain plug and fill with new oil via the dipstick tube.
Both! The gas engine would take oil then the log splitter that runs the hydraulics would take a specific hydraulic fluid. Its best to go by what the manufacture says
my speeco 20 ton model uses Wix 51553 filter.
10w30 for year round use, and 30w for only summer use.
youtube - push mower oil change.... oil plug under mower deck
There is a large allen head pipe threaded set screw (oil Plug) located in a hole under the engine . Remove to drain oil. Becarefull when replacing plug not to over tighten it will crack the case if you turn in to tight.
Click the link and find your engine for the exact capacity.
drain the old oil, replace the oil filer and put in some new oil. need to know where oil filler is
To change the oil on a Craftsman push mower, first, locate the oil drain plug underneath the mower. Place a container underneath to catch the old oil. Remove the drain plug and let the oil drain completely. Replace the drain plug and refill the mower with new oil to the recommended level. Dispose of the old oil properly.
The best way to change the oil on a Craftsman Eager One lawn mower - 6.75 HP is to buy a Toro.
No, the craftsman has a 4.5hp 4 cycle engine, so uses gasoline only. You will need to change the oil in the motor annually.
Every 48 hours/annually, whatever comes first
for oil change it takes 18 oz of 5w30 per manual